https://community.hpe.com/t5/automated-backup/how-to-verify-the-compatibility-ebs123/m-p/652167#M776 usually the EBS compatibility matrix is used to add a new component in a SAN, so you already have some starting point, but if you want to start from scratch:<BR />just check:<BR />A &gt; B<BR />A &gt; C<BR />A &gt; D<BR />then<BR />B &gt; C<BR />B &gt; D<BR />then<BR />C &gt;D<BR />at thee end this is equivalent to A&gt;B&gt;C&gt;D Sat, 29 Apr 2006 09:18:19 GMT meloni 2006-04-29T09:18:19Z https://community.hpe.com/t5/automated-backup/how-to-verify-the-compatibility-ebs123/m-p/652166#M775 Here is the configuration:<BR /> EML103e<BR /> HP storageWorks 4/16 SAN switch<BR /> SUN 280R , solaris9 , X6767A HBA<BR /> NetApp F980 , NDMP<BR /> Veritas Netbackup NBU6<BR /> <BR /> Could somebody guide me how to verify the compatibility ? <BR /> From EBS123-matrix:<BR /> - EML is supported with NBU (but no version specified)<BR /> - SUN/solaris9/X6767A is supported with NBU (also not specify verion)<BR /> <BR /> All info in EBS is like (A,B) is compatable, (B,C) is compatible, (C,D) is compatible, But how about (A,B,C,D) ?<BR /> Thu, 27 Apr 2006 22:52:54 GMT https://community.hpe.com/t5/automated-backup/how-to-verify-the-compatibility-ebs123/m-p/652166#M775 JR_3 2006-04-27T22:52:54Z https://community.hpe.com/t5/automated-backup/how-to-verify-the-compatibility-ebs123/m-p/652167#M776 usually the EBS compatibility matrix is used to add a new component in a SAN, so you already have some starting point, but if you want to start from scratch:<BR />just check:<BR />A &gt; B<BR />A &gt; C<BR />A &gt; D<BR />then<BR />B &gt; C<BR />B &gt; D<BR />then<BR />C &gt;D<BR />at thee end this is equivalent to A&gt;B&gt;C&gt;D Sat, 29 Apr 2006 09:18:19 GMT https://community.hpe.com/t5/automated-backup/how-to-verify-the-compatibility-ebs123/m-p/652167#M776 meloni 2006-04-29T09:18:19Z