https://community.hpe.com/t5/proliant-servers-netservers/netraid-getting-reassignment-error/m-p/181211#M2232 How often do you perform consistancy checks on the RAID array? Usually if a rebuild fails, there is corruption in the array stripes. Fri, 31 Jan 2003 18:46:58 GMT CA660377 2003-01-31T18:46:58Z https://community.hpe.com/t5/proliant-servers-netservers/netraid-getting-reassignment-error/m-p/181210#M2231 One of my LC2000R's has had a drive failure. It appears as if the hot swappable drive did not failover auomatically even though it is set to do so. When I put a new drive in and then try to rebuild it I recieve a =Reassignment error at around 50% of the rebuild then it fails. I am currently sending another drive out to swap. Any ideas...... Fri, 31 Jan 2003 00:23:46 GMT https://community.hpe.com/t5/proliant-servers-netservers/netraid-getting-reassignment-error/m-p/181210#M2231 Paul M. Michelena 2003-01-31T00:23:46Z https://community.hpe.com/t5/proliant-servers-netservers/netraid-getting-reassignment-error/m-p/181211#M2232 How often do you perform consistancy checks on the RAID array? Usually if a rebuild fails, there is corruption in the array stripes. Fri, 31 Jan 2003 18:46:58 GMT https://community.hpe.com/t5/proliant-servers-netservers/netraid-getting-reassignment-error/m-p/181211#M2232 CA660377 2003-01-31T18:46:58Z