topic Re: HPE Microserver gen10+ no video on displayport in ProLiant Servers - Netservers

HPE Microserver gen10+ no video on displayport

justas — Thu, 14 May 2020 13:45:36 GMT

Hello,

This microserver gen10+ is supposed to be connected via VGA for video output? Display port works only when some OS is loaded?

Re: HPE Microserver gen10+ no video on displayport

BPSingh — Fri, 15 May 2020 00:39:21 GMT

Greetings!

As per server quickspecs, Microserver Gen10s comes with Display Ports 1.2

https://h20195.www2.hpe.com/v2/getdocument.aspx?docname=a00008701enw

Are you trying to connect the display port dongle adapter cable to transfer the DisplayPort to a VGA source? If yes, the DisplayPort design for DisplayPort 1.2 requires an “active” dongle adapter cable to transfer video output.

To isolate whether it is display port adapter or display driver issue, please install OS using the VGA port and later switch to display port.

You may also connect to a monitor having display port (i.e. display port to display port connection)

Additonal info:

After OS installation, if Default Audio Device Setting of the Display Port Is Disabled then please following below advisory.

https://support.hpe.com/hpesc/public/docDisplay?docId=emr_na-a00018202en_us

Re: HPE Microserver gen10+ no video on displayport

monstercoo — Sun, 24 May 2020 10:05:33 GMT

Wow, I ran into this issue with a new gen10 plus.

Displayport doesn't work out of the box. You must use vga for intial setup (or ilo).

It's a pain in the butt finding a vga monitor these days. It would be really convienent for displayport to work right from the start.

Re: HPE Microserver gen10+ no video on displayport

BPSingh — Thu, 28 May 2020 15:27:35 GMT

Could you confirm if the display port works fine at the OS level?

Once you confirm, we will have this update passed to the concerned team.

Re: HPE Microserver gen10+ no video on displayport

akvadrako — Tue, 23 Feb 2021 09:14:50 GMT

I can confirm my Displayport does not work during the boot or in the Linux console. Is it supposed to?

Actually I just tried again today and it did indeed work, with the same monitor and cable. Both during the firmware boot and in the console.

Perhaps it was because I plugged in the DP cable before I plugged in the server. Is that the workaround?

Re: HPE Microserver gen10+ no video on displayport

techin — Wed, 24 Feb 2021 09:19:38 GMT

@akvadrako

That sounds like a good workaround

Any thoughts @BPSingh , @monstercoo , @justas

Re: HPE Microserver gen10+ no video on displayport

KTrojok — Tue, 13 Apr 2021 07:35:41 GMT

.. this isn't true, is it? I just bought an Gen 10 Plus and only have digital KVM.

How about a functioning DP port under VMware ESXi? Can you change graphics settings in BIOS?

kind regards
Konrad

Re: HPE Microserver gen10+ no video on displayport

Floyd71 — Mon, 26 Apr 2021 14:24:14 GMT

As I founded, Displaz port can work if showing high resolution picture.

If you want to do basic setup, textual setup of operating system (such are TrueNAS or similar), display port is useless - only connection to iLO can help.

Display port will work if you have installed Windows or similar operating system.