topic Netserver LH4 fails to find the NetRaid controller on boot in ProLiant Servers - Netservers

Netserver LH4 fails to find the NetRaid controller on boot

Bryden Murdoch — Fri, 30 Jul 2004 15:35:58 GMT

The server in question is to be re-assigned use.
So I considered it a good idea to upgrade all the BIOS first.

BIOS updated to 4.06.36PS
hot swap backplane to B.01.26
NetRaid to 03.03 ( I think )

can enable to NetRaid controller in the BIOS but during the boot process it is not identified. Have tried diags etc not no go.

please help

Re: Netserver LH4 fails to find the NetRaid controller on boot

meloni — Tue, 03 Aug 2004 01:41:21 GMT

In the Bios page, the first window allow you to enable the "integrate netraid controller"
but you have also to specify the channels that are to be used, usualy channel A for raid controller only, and channel B as a standard scsi for tape devices.
Also there is another setting related to the boot priority in "configuration > Hard Drive priority", select integrated netraid

Re: Netserver LH4 fails to find the NetRaid controller on boot

Bryden Murdoch — Wed, 11 Aug 2004 07:36:20 GMT

Integrated HP NetRAID is enabled with SCSI channel A included and B excluded.

Config boot device ordering available options
Boot device priority
CD-ROM
Flexible disk
Hard drive
network boot
SYM53C8xx boot support

Hard drive priority
bootable cards

The integrated netraid option for the boot configs is not available.

During the boot process a Symbios scsi device is shown with the following

Symbios SCSI SDMS (TM) V4.0 PCI SCIS BIOS PCI Rev 2.0,2.1
PCI-4.14.04

further suggestions appreciated

Re: Netserver LH4 fails to find the NetRaid controller on boot

meloni — Wed, 11 Aug 2004 07:56:26 GMT

I think you may have a conflict on your Mother board.
I will suggest to clear cmos infos, entering with F11 at boot time when system ask for F2, or clearing whith the jumper on the mother board.
Then at next boot you will have a error message related to cmos checksum, just enter again in the bios and exit "Saving" changes", this will recalculate the checksum.
If this do not clear your problem, try to flash the firmware again and clear CMOS another time.

Hope this will help

marino