P4300: Adding user failed: using protected user name

Arian van der Pijl — Thu, 14 Jan 2010 11:12:28 GMT

After finishing the create management group wizard I see the error message "Adding user failed: using protected user name".
The wizard seems to loop and I had to hard end the CMC.
I used the name 'Admin'.

Restarting the CMC and logging in to the new cluster seems to work and the cluster seems operational.

Any comments on this "Adding user failed: using protected user name" warning?

Regards,
Arian van der Pijl

Re: P4300: Adding user failed: using protected user name

Arian van der Pijl — Thu, 14 Jan 2010 11:31:43 GMT

Console operations instead of CMC:
After system defaults I tried again to add the user 'Admin'.
General settings -> Add Administrator.
Now I got a clear warning of failing to add the user 'Admin' because of protected user.

I knew the usage of admin was used before and therefore I tried to add the user 'admin' (mind the lowercase a).

The user 'admin' was accepted!

Problably cause:
The wizard does accept the protected username 'Admin' and tries to establish a configuration. While configuring the management and cluster an error occurs and leaves the wizard in a looping state.

So beware using the name 'Admin' while using this wizard.

Regards,
Arian van der Pijl

topic P4300: Adding user failed: using protected user name in StoreVirtual Storage

P4300: Adding user failed: using protected user name

Re: P4300: Adding user failed: using protected user name