topic Re: How to take ignite backup ? in Operating System - HP-UX

How to take ignite backup ?

Deepu Chakravarty — Thu, 04 Mar 2004 05:19:30 GMT

How to take ignite backup ? Pls elaborate.
Thanks.

Re: How to take ignite backup ?

Jeff Schussele — Thu, 04 Mar 2004 05:22:12 GMT

Hi,

Use the make_tape_recovery command like:

/opt/ignite/bin/make_tape_recovery -a /dev/rmt/0mn -Ivx inc_entire=vg00

This assumes your tape drive is /dev/rmt/0mn & that you want your entire vg00 VG.
man make_tape_recovery for details.

HTH,
Jeff

Re: How to take ignite backup ?

Sanjay Kumar Suri — Thu, 04 Mar 2004 05:22:48 GMT

Check this link:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=61278

sks

Re: How to take ignite backup ?

Deepu Chakravarty — Thu, 04 Mar 2004 05:23:00 GMT

More info. please:
HP-UX PA-RISC 8700 64 bits
OS 11.11

Re: How to take ignite backup ?

Jeff Schussele — Thu, 04 Mar 2004 05:23:15 GMT

Dang forum font....

That's a cap i - NOT an l (ell).

Jeff

Re: How to take ignite backup ?

G. Vrijhoeven — Thu, 04 Mar 2004 05:25:33 GMT

Hi,

Old:

make_recovery -ACivd /dev/rmt/0m

assuming /dev/rmt/0m is you drive:
ioscan -fnkCtape

New version:

make_tape_recovery -s myserver -x inc_entire=vg00

check man pages, for more info.

HTH,

Gideon

Re: How to take ignite backup ?

Naveej.K.A — Thu, 04 Mar 2004 05:25:48 GMT

check for Ignite UX installed on your system

swlist |grep -i ignite

make_tape_recovery for 11.0 and above

and make_recovery for the older systems i.e. 10.x...

man make_tape_recovery for details

my ignite backup is taken using

make_tape_recovery -x inc_entire=vg00 -lv -a /dev/rmt/0m

with best wishes
naveej

Re: How to take ignite backup ?

Shaikh Imran — Fri, 05 Mar 2004 04:46:28 GMT

1) Ignite Unix B.x version is for HP-Unix 11.x & A.x version for HP-Unix 10.x.
2) Ignite unix is a backup & recovery utility which creates a Golden Image of the HP-UX system.

BACKUP:
@ To create a system recovery archive of entire root disk volume :
a) default tape device = /dev/rmt/0m
b) Load the tape
c) #make_tape_recovery -x inc_entire=vg00

A tape will be created without further interactions.

@To create the complete system backup

a) Load the tape
b) make_tape_recovery -A

A Tape will be created without further interaction.You can boot this tape on your new system.

RECOVERY:

a) load the system recovery tape in the tape drive
b) boot the system
c) Interrupt the boot sequence to redirect it to the tape drive.
d) Cancel the non-interactive installation by pressing any key when given the opportunity.
e) Allow the installation process to complete.

Regards,

Imran Shaikh