topic Re: N4000 in Operating System - HP-UX

N4000

Rui Medeiros_1 — Thu, 15 Apr 2004 10:42:42 GMT

> Here is the error message that was on the console
>
> System Name: Uninitialized
>
> DATE 04/15/2005 TIME: 08:25:30
>
> ALERT LEVEL: 6= Boot possible, pending failure - action required
>
> REASON FOR ALERT
>
> SOURCE 8=I/O
>
> SOURCE DETAIL: 3=local bus adapter SOURCE ID: FF
> PORBLEM DETAIL: 6=configuration error
>
> LED RUN ATTENTION FAULT REMOTE POWER
> FLASH FLASH OFF ON ON
>
> 0x2000106683FF2164 000101FF FF06FF83 - type 4=Physical Location
> 0x5800106683FF2164 00006803 0F08191E - type 11=Timestamp
> 04/15/2004 08:25:30

Re: N4000

Jeff Schussele — Thu, 15 Apr 2004 10:44:03 GMT

Hi Rui,

Sounds like you've had a hardware failure.
You should place a HW service call to HP to replace the failed part.

Rgds,
Jeff

Re: N4000

SS_6 — Thu, 15 Apr 2004 10:51:29 GMT

Look like some hardware problem. Make sure you also have make_recovery tape in case you need it.

Re: N4000

Sanjay_6 — Thu, 15 Apr 2004 10:54:06 GMT

Looks like a problem.

Alert Level 6 decodes as -> Boot possible, pending failure or environmental problem with action required (e.g., boot disk error rate above threshold, power failure, overtemp medium).

What was the cause of this problem. Did you add a new hardware and boot or is the system running and you got this message. Could be a controller problem. Has EMS logged anything if the system is running.

Hope this helps.

Regds