https://community.hpe.com/t5/operating-system-hp-ux/pv-move-failure/m-p/3294183#M182716 hi,<BR /><BR />as seen in the attachment, i notice that your pv1 and pv2 is "gone" (with the stale condition) but pv3 is still okay.<BR /><BR />u may like to read this on how to replace a failed mirrored non-root disk:<BR /><BR /><A href="http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&amp;docId=200000071483991" target="_blank">http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&amp;docId=200000071483991</A><BR /><BR />regards.<BR /> Wed, 02 Jun 2004 23:32:45 GMT Joseph Loo 2004-06-02T23:32:45Z https://community.hpe.com/t5/operating-system-hp-ux/pv-move-failure/m-p/3294182#M182715 I recently had a drive start to fail on me and in an effort to grab as much data off it before complete failure i ran a pvmove. Well that failed in the middle and now my Logical Volume will not sync back to a new disk or mount. Here's an output of the lvdisplay command showing the 2nd mirror that it created when it started the PVmove. anyone with any suggestions? Wed, 02 Jun 2004 15:01:31 GMT https://community.hpe.com/t5/operating-system-hp-ux/pv-move-failure/m-p/3294182#M182715 Jeff Aylstock 2004-06-02T15:01:31Z https://community.hpe.com/t5/operating-system-hp-ux/pv-move-failure/m-p/3294183#M182716 hi,<BR /><BR />as seen in the attachment, i notice that your pv1 and pv2 is "gone" (with the stale condition) but pv3 is still okay.<BR /><BR />u may like to read this on how to replace a failed mirrored non-root disk:<BR /><BR /><A href="http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&amp;docId=200000071483991" target="_blank">http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&amp;docId=200000071483991</A><BR /><BR />regards.<BR /> Wed, 02 Jun 2004 23:32:45 GMT https://community.hpe.com/t5/operating-system-hp-ux/pv-move-failure/m-p/3294183#M182716 Joseph Loo 2004-06-02T23:32:45Z