topic Re: Question on Syslog entry in Operating System - HP-UX

Question on Syslog entry

Bill Anderson_2 — Tue, 10 Aug 2004 12:40:27 GMT

Could anyone point me in the right direction or shed some light for this syslog entry?

*************************************

Aug 9 09:24:36 midas EMS [2194]: ------ EMS Event Notification ------ Value: "CRITICAL (5)" for Resource: "/adapters/events/TL_adapter/0_7_0_0" (Threshold: >= " 3") Execute the following command to obtain event details: /opt/resmon/bin/resdata -R 143785989 -r /adapters/events/TL_adapter/0_7_0_0 -n 143785986 -a

**************************************
TIA,
Bill

Re: Question on Syslog entry

melvyn burnard — Tue, 10 Aug 2004 12:45:50 GMT

you have had diagnostic errors logged against what appears to be a Fibre Channel card
run the command it informs you to run and you will get more details

Re: Question on Syslog entry

rvrameshbabu — Tue, 10 Aug 2004 12:48:38 GMT

This error message is from HP - EMS ( Hardware monitoring system )
--
$ swlist -l "product" | grep -i ems
EMS-Config A.03.20 EMS Config
EMS-Core A.03.20 EMS Core Product
EMS-KRMonitor A.11.00.04 EMS Kernel Resource Monitor
--

refer the below url for more details .

http://docs.hp.com/hpux/onlinedocs/2512/B6191-90029.pdf

http://docs.hp.com/hpux/onlinedocs/4316/ems_quick.pdf

Re: Question on Syslog entry

Sundar_7 — Tue, 10 Aug 2004 12:54:15 GMT

Error message was generated by the EMS for the adapter installed at the hardware address 0/7/0/0.

Severity is critical, so chances are that you have a serious hardware failure.

# ioscan -fnH 0/7/0/0

Re: Question on Syslog entry

Bill Anderson_2 — Tue, 10 Aug 2004 13:54:24 GMT

Thanks to all! Great info!

Points awarded!

Regards,
Bill

Re: Question on Syslog entry

Alzhy — Tue, 10 Aug 2004 13:57:49 GMT

Bill,

Is your environment by any chance a SAN that has an EVA on it? And running SecurePath software?

If you do, then chances are the SecurePath instructions were not followed to the letter. You must disable EMS monitoring of your FC Paths in a SecurePath+EVA/StorageWorks environment. Even with SecurePath 3.0D, this is still a requirement.

Re: Question on Syslog entry

Bill Anderson_2 — Tue, 10 Aug 2004 14:07:58 GMT

Nelson,

After talking with the sysadmin, it appears that this was generated during configuration the new system which is mirroring the old system for conversion to the new system.

Thanks for your info, I did pass it along.

Bill

Re: Question on Syslog entry

Alzhy — Tue, 10 Aug 2004 14:10:53 GMT

I think you may very well have an EVA system and your SysAdmn is doing snapclones.. and I will advice him to make sure EMS is not active on the EVA FC. paths..