when sam configure..

mark.M — Fri, 26 Aug 2005 20:07:08 GMT

xqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqx
xNetl Note (gogh) k x
xqqqx xqqqx
x x After application of the parameter modification(s), one or more x x
x x kernel parameters were found to violate their minimum or maximum x x
xlqqx allowable values. The values of these parameters have been adjusted xqk x
xx x as shown in the table below: x ^ x
xx x x x
xx x Parameter Old Value New Value x x
xx x --------------------------------------------------------------- x x
xx x n2z_max_zstrbuf_pgs 0x8 0x1 x x
xx x n2z_outb_buffer_sz 0x1000 0x1 x x
xx xqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqx x
xx x [[ OK ]] x x
xx mqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqj

when sam(network configuration) workd..
above log display .. why??

Re: when sam configure..

mark.M — Fri, 26 Aug 2005 20:12:09 GMT

above kernel state config

host:/> kmtune | grep -i n2z
n2z_240b_pktsz_ok 0
n2z_end_to_end_acks 0
n2z_ignore_cts_cd 0
n2z_link_timeout 90
n2z_log_rst_clrs 0
n2z_low_bnd_npkts 3
n2z_max_cards 32
n2z_max_devs 16384
n2z_max_ninb_pkts 6
n2z_max_proto_blks 200
n2z_max_stream_ctx 200
n2z_max_zlu 16384
n2z_max_zstrbuf_pgs 8
n2z_outb_buffer_sz 4096
n2z_pendg_bytes 10000
n2z_pendg_threshold 7
n2z_pendg_wrts 14
n2z_reset_on_attach 0
n2z_rr_policy 0
n2z_t25_disable 0
n2z_trc_active 1
n2z_trc_bufr_len 102400

topic when sam configure.. in Operating System - HP-UX

when sam configure..

Re: when sam configure..