topic Re: HP 9000 Console login Prompt problem in Operating System - HP-UX

HP 9000 Console login Prompt problem

HP-UX admin — Sat, 12 Aug 2006 00:25:56 GMT

Hi ,
I am using HP 9000 L1000 server.On console I am not getting login Prompt after I reset it using d+Power ON .It shows Keyboard locked.
thanks in advance.

Re: HP 9000 Console login Prompt problem

RAC_1 — Sat, 12 Aug 2006 05:05:37 GMT

Reset GSP and check it.

Re: HP 9000 Console login Prompt problem

Yogeeraj_1 — Sat, 12 Aug 2006 05:13:16 GMT

hi
try to

control+D
hold it for a few seconds...

this should soft reset the console.

hope this helps!

kind regards
yogeeraj

Re: HP 9000 Console login Prompt problem

HP-UX admin — Sat, 12 Aug 2006 06:05:21 GMT

Hi,
I have already tried,
1. Ctrl+d
2.stty +queryGSP then GSP is running.
3.stty +resetGSP Cannot reset GSP.
4.Shift+reset
5.stty sane
Ctrl+j
....still same problem.
Also whereis GSP reset button on L1000.
thanks.

Re: HP 9000 Console login Prompt problem

Torsten. — Sat, 12 Aug 2006 06:31:25 GMT

The reset procedure resets the terminal to use the first serial port (and US keyboard, HP emulation, 9600 baud).
You have to adjust the settings, if you use another port.

Unfortunately the reset button is inside the system on the GSP card. You have to open the side access panel to be able to press it.

Re: HP 9000 Console login Prompt problem

V.Manoharan — Sun, 13 Aug 2006 23:09:44 GMT

Hi ,
1. Did you tried up with connecting laptop to the console. so that we can identify whether issue with console or from GSP end.

2. check for the console whether remote is enabled or not. hope f4 f3 key will be used for that.

3. Did you have configured lanconsole by any chance? try connecting with that.

4.Are you using correct cosole cable try swapping if you got another. Normally there will be W/M cable(which will have three ports ups,console,remote) will be connected to the server and 9 pin -9 pin will be connected to console.

Try to isolate whether console have issue or GSP.

Thanks and regards
V.Manoharan