topic Re: Command respawing too rapidly in Operating System - HP-UX

Command respawing too rapidly

Kenneth Yap — Wed, 11 Jul 2001 07:50:55 GMT

Dear Expert,
I have this error display from the console. What is this problem?

NIT: Command is respawing too rapidly
will try again in 5 minutes
Check for possible errors
id: a0 "/usr/lbin/uucp/getty -r -t 60 -h ttyd1p0 9600"

Thanks

Re: Command respawing too rapidly

eran maor — Wed, 11 Jul 2001 08:07:47 GMT

Re: Command respawing too rapidly

Rainer von Bongartz — Wed, 11 Jul 2001 08:11:32 GMT

look at yout /etc/inittab file

there you will find this entry and in the second field you see the keword respawn. this means restart this command. In your case there is a problem with your getty on /dev/ttyd1p0 (probably a modem) and this causes getty to die and be re-spawned.
As this happens continously this messages on /dev/console is displayed.

check your (modem ??) connection on /dev/ttyd1p0

Re: Command respawing too rapidly

Thomas Schler_1 — Thu, 12 Jul 2001 07:44:56 GMT

I got quite similar error messages after installing patch PHSS_24190.

If you also had installed this patch, recently, you would have to move /opt/wt/newconfig/usr/lib/X11/extensions/libSX.1010 or /opt/wt/newconfig/usr/lib/X11/extensions/libSX.1020 (depending on your HPUX version) to /usr/lib/X11/extensions and rename it to libSX.1.

Re: Command respawing too rapidly

Systems Department — Thu, 12 Jul 2001 12:23:53 GMT

Hi Kenneth

It is likely that you could also be experiencing problems with the serial device attached to port ttyd1p0. Check this device, try it on another port.

If there is a cable plugged into that port and no device attached to the end of it you will also get this error message. Check that there are no cables connected which have no devices on the end.

If it is a modem connected onto that port then the cable could be of the wrong specification, check your cable.

Graeme.