topic Re: Convert Printer - Remote to Network in Operating System - HP-UX

Convert Printer - Remote to Network

brian_31 — Wed, 24 Jan 2007 17:20:16 GMT

I need to convert this printer from remote to network..what would be the steps? can i use SAM?

P177 - name
IP: 10.62.200.30
Model: HPLJ5SI

Also how would i identify if it is set up as a network or remote printer now? would SAM help that too? we have hppi installed.

Thanks

Brian

Re: Convert Printer - Remote to Network

Tim Nelson — Wed, 24 Jan 2007 17:26:39 GMT

Never use SAM here.....

Make sure the HP Jet Direct printer installer is installed. You can find this on HP's website.

remove printer
lpshut
lpadmin -xP177

add new printer as network based.
lpadmin -pP177 -mlaserjet -v/dev/null
accept P177
enable P177
cp /etc/lp/interface/P177 to /etc/lp/interface/model.orig/P177
cp /opt/hpnpl/sh/hpnp.model /etc/lp/interface/P177
edit /etc/lp/interface/P177 and change line where PERIFH="" to PERIFH=hostname/IP
also mod PORT="" to PORT="9100 or 9101 or 9102" for multiport jetdirect leave blank if only a single port.

lpsched
lp -dP177 /etc/copyright
to test.

Re: Convert Printer - Remote to Network

Tim Nelson — Wed, 24 Jan 2007 17:33:01 GMT

The jetdirect printer installer software is on the HP business support website. Search for it by name or reference the below.

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=18972&prodSeriesId=27349&prodNameId=18922&swEnvOID=7&swLang=8&mode=2&taskId=135&swItem=ja-6671-1

Re: Convert Printer - Remote to Network

brian_31 — Wed, 24 Jan 2007 17:42:10 GMT

Thanks. What command would show that it is a remote printer now and i can use the same command to verify that it is a network printer later?

Thanks

Brian

Re: Convert Printer - Remote to Network

A. Clay Stephenson — Wed, 24 Jan 2007 17:49:16 GMT

To identify remote printers, execute "lpstat -vmyprinter" or simply "lpstat -v". Remote printers will include the line "remote to: xxxx on aaa.bbb.ccc.ddd"; network printers will not have that line.

Re: Convert Printer - Remote to Network

Tim Nelson — Wed, 24 Jan 2007 17:53:50 GMT

Network type of printers always have their device as /dev/null ( as will printers hung from a terminal server unless the terminal server supports lpd, then it will show as a remote if configured properly )

remotes will state as mentioned above "remote ..... "

physically connected printers to an actual lp port or serial port with have a hard device name i.e. /dev/lpX or /dev/xyz.