topic Re: diagnostics in Operating System - HP-UX

diagnostics

Jeff Hagstrom — Thu, 23 Aug 2001 12:55:17 GMT

I am trying to figure my physical memory and swap space setup on my machine. When I entered /usr/sbin/dmesg | grep -i Physical I got a message "CAN'T READ KERNAL MEMORY". What does this message mean? and how can I figure out how much memory the machine has?

Re: diagnostics

Alex Glennie — Thu, 23 Aug 2001 13:20:17 GMT

You need to be root user for dmesg to run, that's the most likely cause of the error .

Re: diagnostics

Sachin Patel — Thu, 23 Aug 2001 13:24:41 GMT

Hi Jeff,
use swapinfo -a for your swap sape information.
use folloing for your physical memory
echo phys_mem_pages/D | adb /stand/vmunix /dev/kmem

Sachin

Re: diagnostics

nancy rippey — Thu, 23 Aug 2001 13:24:57 GMT

If you have stm try
echo "selclass qualifier memory; info; wait; infolog" | cstm > /tmp/meminfo

nancy

Re: diagnostics

linuxfan — Thu, 23 Aug 2001 13:29:38 GMT

Hi Jeff,

On a 10.X machine you could run
echo physmem/D | adb -k /stand/vmunix /dev/kmem

On a 11.X machine,
echo phys_mem_pages/D | adb -k /stand/vmunix /dev/kmem

Or you could run "/usr/sam/lbin/getmem" (returns the amount of memory in MB)

You need to be root to run dmesg or the above command

-HTH
Ramesh

Re: diagnostics

Deshpande Prashant — Thu, 23 Aug 2001 13:32:58 GMT

HI
If you have glance software installed, Press m (memory) in main menu to get details about total memory and memory in use.

You also will be able to use cstm to find out details about physical memory installed in your system.
#cstm
cstm>map
cstm>sel dev
cstm>il (This will show you details of memory installed).

Thanks.
Prashant Deshpande.

Re: diagnostics

MANOJ SRIVASTAVA — Thu, 23 Aug 2001 13:48:46 GMT

Hi Jeff

To know the Physical memory you have the following ways

1. SAM-->Performance Monitor ---> System Properties --> Memory.

2. Glance

3. echo phys_mem_pages/D | adb /stand/vmunix /dev/kmem

4. dmesg | grep Phy ( incase dmesg doent work then either you dont it as a root or the dmesg is not working properly )

You can also try

cat /var/adm/syslog/OLDsyslog.log | grep Phy incase your dmesg doesnt work.

Manoj Srivastava

Re: diagnostics

Sundar_7 — Fri, 24 Aug 2001 08:23:39 GMT

Hi,

Are U running as a normal user..

dmesg has to read from /dev/kmem which might not be readable by a normal user..

This is just a guess as right now I cannot go for checking it..

Make sure U are running as root..

But if U only need to find out the amount of memory..

dmesg cannot always help it out as it can be overrided by further kernel messages..

so go for

# /usr/sam/lib/getmem

# echo phys_mem_pages/D |
adb -k /stand/vmunix /dev/kmem