topic Re: HP-UX 11.11. Add tape drive in Operating System - HP-UX

HP-UX 11.11. Add tape drive

Tove Myhre — Tue, 04 Dec 2007 14:05:29 GMT

Hello.

Try to find a tape drive with SAM.
Get message :

From the list of all device drivers that support tape drives the
following drivers are not configured into the kernel:

c8xx, schgr, scsi1, spt, spt0, stape, tape2, target

The absence of one or more of these drivers may be the reason that
SAM is unable to find the tape drive. If you want to add only a
subset of this list of drivers you can do this by selecting "No",
continue cancelling out of this subarea of SAM and enter Kernel
Configuration.

Do you want SAM to add all of these drivers at this time?

What happens if I answer yes?
Do this mean that I change the kernel config?
And must I reboot the server to activate the changes?

Re: HP-UX 11.11. Add tape drive

Robert-Jan Goossens — Tue, 04 Dec 2007 14:30:17 GMT

Hi,

What kind of tape drive are you adding to te server?

What happens if I answer yes? all above drivers will be added to the kernel.

Do this mean that I change the kernel config? Yes

And must I reboot the server to activate the changes? Yes

Regards,
Robert-Jan

Re: HP-UX 11.11. Add tape drive

Tove Myhre — Tue, 04 Dec 2007 14:40:09 GMT

Thank you!
I can't boot the server without planning and informing users. Will kernel update start an automatic reboot?

I dont know this system very well. And the servers is on another location. But I think it's ordinary HP (local) tape drives.

Re: HP-UX 11.11. Add tape drive

Robert-Jan Goossens — Tue, 04 Dec 2007 14:53:21 GMT

Probably you will need the stape driver, but if you don't have the tape model it is a guess.

http://docs.hp.com/en/B2355-90698/ch07s02.html

Regards,
Robert-Jan

Re: HP-UX 11.11. Add tape drive

Tove Myhre — Tue, 04 Dec 2007 15:32:19 GMT

Thank you again :) Very helpful answers. I will continue with this case later this week or next.

Re: HP-UX 11.11. Add tape drive

Steven E. Protter — Tue, 04 Dec 2007 15:39:27 GMT

Shalom,

You can narrow the range of options as follows:

ioscan -fnC tape

Device must be connected and powered up.

Then we can find out for sure what driver you need. Its probably stape though.

Adding stape will definitely require a boot.

SEP

Re: HP-UX 11.11. Add tape drive

Tove Myhre — Tue, 06 May 2008 10:57:22 GMT

That took some time!

I had to install stape. And i was recommended to halt! the system's (3 servers) so i did that too. And it worked!
So thank you all for good advices.

Tape model is C5683A.
I got it whith ioscan.

Regards
Tove