topic Re: EMS: The selected monitor is currently not available in Operating System - HP-UX

EMS: The selected monitor is currently not available

Rainer von Bongartz — Tue, 16 Oct 2001 06:35:25 GMT

I'm trying to configure a monitor in the Event Monitoring Services (EMS)

Selecting the Resource Hierarcy
/storage/status/disk_arrays in SAM I always get the response
ERROR: The selected monitor is currently not abailable

Currently BTW. in this context means at least for a couple of hours now.

What can be the problem and how to fix it ??

Re: EMS: The selected monitor is currently not available

Michael Tully — Tue, 16 Oct 2001 06:58:42 GMT

Hi Rainer,

I suggest you forget about SAM and start the
program directly from it's source.

# /etc/opt/resmon/lbin/monconfig

Have a look at the attached document about EMS
it discusses tapes, but the concept is the
same for setting things up.

Good Luck
-Michael

Re: EMS: The selected monitor is currently not available

Animesh Chakraborty — Tue, 16 Oct 2001 07:11:50 GMT

Hi,
Make sure that you are using latest version of EMS .

Regards
Animesh

Re: EMS: The selected monitor is currently not available

Animesh Chakraborty — Tue, 16 Oct 2001 07:56:21 GMT

hi,
To identify the EMS release in use on your system, perform the
following: In the directory /etc/opt/resmon/lbin run:

$what p_client registrar
p_client:
EMS (A.03.20)
registrar:
EMS (A.03.20)

Animesh

Re: EMS: The selected monitor is currently not available

Carsten Krege — Tue, 16 Oct 2001 14:48:37 GMT

You can use SAM to configure the monitor request.

As a prerequisite you should enable monitoring with monconfig.

# /etc/opt/resmon/lbin/monconfig

If you did this already, I suggest to disable and enable monitoring with monconfig and retry.

If this wasn't successful, check whether the disk_em process is running. If it does, kill it and retry.

You might want to check the logs in /etc/opt/resmon/log.

It is a good idea to run a recent version of the OnlineDiag bundle and to have patches for EMS 3.20 installed.

Carsten