https://community.hpe.com/t5/operating-system-hp-ux/cstm-problems/m-p/4322457#M340889 <!--!*#-->I am new to cstm; however, when you load cstm it takes around 30 seconds before you finally get your prompt, which on most of our systems it takes only 2 to 3 seconds.<BR /><BR />When you type in map it should display information; however, I am getting ***NO CURRENT SYSTEM***<BR /><BR /><BR />MODEL - rp34440<BR />OS Version - HP11.11<BR />OnlineDiag Version - B.11.11.16.09<BR /><BR />NOTE- We have the same above information on others hosts and have no problem using cstm.<BR /><BR />Any thoughts on what could be causing the slowness and no current system? Fri, 12 Dec 2008 15:47:53 GMT Michael_695 2008-12-12T15:47:53Z https://community.hpe.com/t5/operating-system-hp-ux/cstm-problems/m-p/4322457#M340889 <!--!*#-->I am new to cstm; however, when you load cstm it takes around 30 seconds before you finally get your prompt, which on most of our systems it takes only 2 to 3 seconds.<BR /><BR />When you type in map it should display information; however, I am getting ***NO CURRENT SYSTEM***<BR /><BR /><BR />MODEL - rp34440<BR />OS Version - HP11.11<BR />OnlineDiag Version - B.11.11.16.09<BR /><BR />NOTE- We have the same above information on others hosts and have no problem using cstm.<BR /><BR />Any thoughts on what could be causing the slowness and no current system? Fri, 12 Dec 2008 15:47:53 GMT https://community.hpe.com/t5/operating-system-hp-ux/cstm-problems/m-p/4322457#M340889 Michael_695 2008-12-12T15:47:53Z https://community.hpe.com/t5/operating-system-hp-ux/cstm-problems/m-p/4322458#M340890 I decided to bounce the diagmond process by issuing /sbin/init.d/diagnostic stop/start<BR /><BR />This forced another scan of the system and populated the map table. <BR /><BR />Slowness is gone and map is now populated.<BR /><BR /> Fri, 12 Dec 2008 16:13:30 GMT https://community.hpe.com/t5/operating-system-hp-ux/cstm-problems/m-p/4322458#M340890 Michael_695 2008-12-12T16:13:30Z