topic Re: scsictl error when setting immediate_reporting in Operating System - HP-UX

scsictl error when setting immediate_reporting

Curtis Deese — Mon, 28 Dec 2009 15:20:23 GMT

We have immediate_reporting set to 1 on devices /dev/rdsk/c24t0d0 and /dev/rdsk/c26t0d0 and want to change immediate_reporting to 0 on these devices. We get the following error:

root@prdmarcs:/sbin/init.d $ scsictl -m ir=0 -m queue_depth=8 /dev/rdsk/c26t0d0
scsictl: Device ioctl (set immediate_report) error: I/O error
root@prdmarcs:/sbin/init.d $

The immediate_reporting value remains 1. It was set to 0 by default when the devices were created. We tried rebooting the machine. How can we force immediate_reporting to 0?

Re: scsictl error when setting immediate_reporting

Mark Fenton — Tue, 29 Dec 2009 00:05:49 GMT

I only have an HP-UX 11.11 system to look at, and you don't specify which version you are attempting this on, nor what storage system you're addressing, which may also play in this regard.

It doesn't appear that I can change that parameter on my system for SAN disks, though I can for direct-attached disks.

HTH

Re: scsictl error when setting immediate_reporting

Curtis Deese — Tue, 29 Dec 2009 12:50:14 GMT

Mark,

We are using HP-UX 11.11 and the storage system is an LSI disk array.

Thanks,

Curtis

Re: scsictl error when setting immediate_reporting

Bill Hassell — Tue, 29 Dec 2009 19:01:58 GMT

> ...is an LSI disk array.

Wow, that sure doesn't help much. LSI Corp. has dozens of products from ICs used in drives to HBAs and RAID controllers, etc. scsictl is used only with real disks, not LUNs presented as virtual disks by a smart array controller. Is your LSI array just a bunch of disks in a small cabinet with a simple SCSI cable? Or can you configure the array to specify the size of the disk(s) presented to your system? I suspect that this question would be answered more accurately from LSI.

Re: scsictl error when setting immediate_reporting

Curtis Deese — Wed, 30 Dec 2009 18:47:54 GMT

RESOLUTION:

We resolved the problem by going into the SANTricity software that is used to manage the array, right-clicking on the LUN, going into the cache settings, and disabling the "write-cache enable" setting. Then, we were successful in setting the immediate_report value to 0 through the scsictl command. We have an LSI SAN connected by two fibre channel cables to a switch and the switch is connected by two fibre channel cables each to our HP-UX servers, which run HP-UX 11.11.