topic Re: Configuring Token Ring on K Class in Operating System - HP-UX

Configuring Token Ring on K Class

Andrew Duncalfe — Wed, 28 Nov 2001 14:37:15 GMT

Can anyone help?

I have just built a K class from an ignite image and added the token-ring patch need for my environment. I then try to configure the token-ring via sam (network Interface Cards) but when I try to add the changes I get the following message

"You must configure one or more of the aliases for this internet address because there is more than one LAN card on the system, use the 'Configure Aliases for Internet Address' button.

There is a second unconfigured LAN card for the ethernet.

All ideas very welcome...

Re: Configuring Token Ring on K Class

nancy rippey — Wed, 28 Nov 2001 14:47:56 GMT

You may want to try to configure it manually in /etc/rc.config.d/netconf

Hope this help

Re: Configuring Token Ring on K Class

Andrew Duncalfe — Wed, 28 Nov 2001 15:04:02 GMT

I have configured netconf but in SAM under Network Interface cards I still need to enable the token ring - but I can't save the changes as per my previous email.

Re: Configuring Token Ring on K Class

nancy rippey — Wed, 28 Nov 2001 15:19:41 GMT

Try using ifconfig to enable to interface
ifconfig lan# up