https://community.hpe.com/t5/operating-system-hp-ux/linkloop-errors/m-p/2423414#M424 Hi<BR /><BR />When using following command<BR /><BR />linkloop -i1 -n2 -v 0x08000987F307<BR /><BR />the response is<BR />get_mesg2 getmesg faile, errno=4<BR /><BR />Any ideas??<BR /><BR />It's the correct NM No<BR />Card and system are working fine<BR /><BR /><BR />Thanks<BR /><BR />Steve<BR /> Thu, 18 May 2000 15:18:25 GMT Steve Massey_1 2000-05-18T15:18:25Z https://community.hpe.com/t5/operating-system-hp-ux/linkloop-errors/m-p/2423414#M424 Hi<BR /><BR />When using following command<BR /><BR />linkloop -i1 -n2 -v 0x08000987F307<BR /><BR />the response is<BR />get_mesg2 getmesg faile, errno=4<BR /><BR />Any ideas??<BR /><BR />It's the correct NM No<BR />Card and system are working fine<BR /><BR /><BR />Thanks<BR /><BR />Steve<BR /> Thu, 18 May 2000 15:18:25 GMT https://community.hpe.com/t5/operating-system-hp-ux/linkloop-errors/m-p/2423414#M424 Steve Massey_1 2000-05-18T15:18:25Z https://community.hpe.com/t5/operating-system-hp-ux/linkloop-errors/m-p/2423415#M425 What are you trying to linkloop to?<BR /><BR />The following could be a possible anser to the symptom you are experiencing:<BR /><BR />1) device you are trying to connect to is not on same subnet<BR />2) switch or another network device blocks linkloop packets at hw level<BR />3)device you are trying to connect to is bad<BR /><BR />Just a few suggestions. Thu, 18 May 2000 20:03:01 GMT https://community.hpe.com/t5/operating-system-hp-ux/linkloop-errors/m-p/2423415#M425 melvyn burnard 2000-05-18T20:03:01Z