topic Re: Anyone using LTO4 drive with 11.23 Itanium yet? in Operating System - HP-UX

Anyone using LTO4 drive with 11.23 Itanium yet?

Bill Hu — Wed, 29 Aug 2007 16:43:45 GMT

Our new LTO4 drive arrive today. I am ready to plug in via ultra320 SCSI card. Server is rx3600 with 11.23.

Since the drives are so new was wondering if this will be recognized. The o/s is patched up to the September 2006 level.

I'm guessing I may need the Hardware enablements patches from June2007 and possibly even the Ultra320 scsi driver update that came with that same DVD.

Any thoughts?

Re: Anyone using LTO4 drive with 11.23 Itanium yet?

Steven E. Protter — Wed, 29 Aug 2007 17:04:47 GMT

Shalom,

The original install on that system is supposed to be September 2006, not something earlier plus patches.

I think you are right abou the June 2007 HWE however.

I mistook the raid card in one of those boxes for a scsi card, tried to hang an LTO3 drive on it and got no joy until I put a SCSI card in and connected the drive to it. The Raid card interface fit fine, but could not talk to the drive.

So you might want to make sure you aren't plugged into the RAID card.

Check the kernel for the stape driver, if its an hp drive. Different driver for an IBM tape drive. If the right driver is not in the kernel you'll need to recompile the kernel with the driver in it. That requires a reboot.

Then patch the box.
SEP

Re: Anyone using LTO4 drive with 11.23 Itanium yet?

tkc — Wed, 29 Aug 2007 21:24:28 GMT

Make sure these 2 patches are installed and configure :

PHKL_36122 : s700_800 11.23 Cumulative kernel SCSI patch
PHKL_31500 : s700_800 11.23 Sept04 base patch

Re: Anyone using LTO4 drive with 11.23 Itanium yet?

D Block 2 — Wed, 29 Aug 2007 21:32:14 GMT

can you verify your install using the HP Tape Utils ?

http://h18006.www1.hp.com/products/storageworks/ltt/index.html

Re: Anyone using LTO4 drive with 11.23 Itanium yet?

Bill Hu — Thu, 30 Aug 2007 10:26:47 GMT

I connected everything and it seems to work ok, even with the Sept. 2006 version of the o/s. It is an HP LTO4 drive, not IBM.

I will go ahead and patch anyway, but does not appear to required.

Re: Anyone using LTO4 drive with 11.23 Itanium yet?

Bill Hu — Thu, 30 Aug 2007 10:51:13 GMT

tkc - Did you have a specific reason for recommending PHKL_36122? Did you experience a system panic using LTO4 without it?

I am still on PHKL_33361 Cumulative kernel SCSI patch even after applying all the June 2007 patch bundles.

Thanks