topic Re: parmodify command from a vpar : question. in Operating System - HP-UX

parmodify command from a vpar : question.

RAJD1 — Fri, 21 Oct 2011 10:58:24 GMT

Hi Experts,

I am having 3 vpar in npar#0 , I would liek to change the boot disk right now it is pointing to vpar1, I want to chagne boot disk of npar to vpar2.

Is it possible to use parmodify command and to change the boot disk from sitting in the vpar.

Thanks in advance.

RAJD1 — Fri, 21 Oct 2011 11:13:00 GMT

Question : from vpar1:> can I run : # parmodify -p 0 -b 2/1/1/0/2/0.6.0

And then reconfiguration reboot. Is it going to store in the npar configuration,

Thanks.

RAJD1 — Fri, 21 Oct 2011 11:20:15 GMT

Experts,

seems I got a solution, the server is PA-RISC , and seems for PA-RISC parmodify is supported withing /from a vpar.

(below in : 2nd bullet having the answer)

To modify stable storage, you must either:

go into standalone/nPars mode and use setboot or parmodify
use parmodify for PA-RISC nPartitionable servers (parmodify is not supported from within the vPars environment on Integrity servers)
go to the BCH for PA-RISC or EFI Shell for Integrity systems

Thanks...