topic Re: Using update-ux on DRD clone in Operating System - HP-UX

Using update-ux on DRD clone

Fidel Ramirez_1 — Thu, 17 Nov 2011 23:49:35 GMT

I'm posting this again as I received no response.

I want to update a current HP-UX 11.23 system to HP-UX 11.31 but I would like to see if using DRD can do the task with minimum down time.

Here are the steps I’m thinking doing:

1. Clone the current active system

drd clone -v -t /dev/dsk/c2t1d0

2. Install update-ux from HP-UX 11.31 media (or depot)

swinstall –s /dvd Update-UX

3. Update the inactive image

drd runcmd update-ux –s /dvd HPUX11i-VSE-OE

4. Activate the clone on next reboot

drd activate

My question is on step 3 where apparently drd runcmd update-ux won’t work on HP-UX 11.23 to update it to HP-UX 11.31.

Thank you in advance.

Re: Using update-ux on DRD clone

Patrick Wallek — Fri, 18 Nov 2011 02:29:33 GMT

You should also do step 2 as a 'drd runcmd' command as you will want Update-UX on the drd clone.

Apart from that, follow the Installing/Updating guide for specific steps. I haven't checked in a while but there may also be a section on updating a drd clone.

Re: Using update-ux on DRD clone

Fidel Ramirez_1 — Fri, 18 Nov 2011 16:41:42 GMT

Hi Patrick,

Thank you for your response.

You are right; I can install the update command on the clone also.

Since nobody responded, I will have to run the commands and test it.

Thank you again,

Fidel