topic Adding spare disk to a VG. in Operating System - HP-UX

Adding spare disk to a VG.

Dee Jacobs — Mon, 08 Oct 2012 16:31:12 GMT

I added a spare disk to a VG on node 1 of a 2 node system using instructions in the sys admin guide: LVM p. 77. HPUX B.11.31. The spare is reported in vgdisplay. It's also recorded in lvmtab.

How do I get it to show on node 2? I deactivated on node1 then went to node2 and activated. It was not there. There are no more instructions in that section of the book. As usual, it must be hidden somewhere else with no link to it.

Re: Adding spare disk to a VG.

Patrick Wallek — Mon, 08 Oct 2012 16:44:12 GMT

I believe you need to treat this exactly as would if you added any disk to a MC/SG VG.

On the Primary node

1) Run 'vgexport -p -v -s -m /tmp/vgname.map vgname'

2) Copy the /tmp/vgname.map file to the secondary node.

On the secondary node

3) remove the vg via 'vgexport vgname' (vgexport vg01)

4) Recreate the /dev/vgname directory and /dev/vgname/group file (mkdir & mknod respectively)

5) Import the VG via 'vgimport -v -s -m /tmp/vgname.map vgname'

Use the appropriate VG name (vg01, vgora, vgme, etc) in the commands above where I have 'vgname'.

Now your VG configuration should be the same on both nodes.

Re: Adding spare disk to a VG.

Dee Jacobs — Tue, 09 Oct 2012 11:42:15 GMT

Thanks again, Patrick.
Very good solution.