topic Re: Ignite Disk Detection on Integrity Server in Operating System - HP-UX

Ignite Disk Detection on Integrity Server

ignite_ux — Thu, 18 Oct 2007 12:02:36 GMT

I am going to install HP-UX 11i v2 on rx6600. server but at the begining stage of intallation of Ignite-UX it cannot detect any hard disks, while i am using SAS controller equiped with two 146GB hard disks.
already i have updated the SAS firmware and EFI driver and created an IM Array with RAID (without Global Spare) as well.
PLEASE URGENT HELP.

Re: Ignite Disk Detection on Integrity Server

Torsten. — Thu, 18 Oct 2007 12:31:37 GMT

What release date of your install media?
It needs to be at least sept. 06 to support this hardware.

Re: Ignite Disk Detection on Integrity Server

ignite_ux — Fri, 19 Oct 2007 23:47:22 GMT

dear

the media version is B.11.23 June 2006. and this is the original media shipped with the Server. so do you think that i should prepare a new one?

Re: Ignite Disk Detection on Integrity Server

Torsten. — Mon, 22 Oct 2007 00:36:34 GMT

You are right, it is the june release,
http://docs.hp.com/en/5991-5311/ch02s03.html

Check your RAID config again.
What RAID controller do you have?

Re: Ignite Disk Detection on Integrity Server

ignite_ux — Tue, 23 Oct 2007 04:01:57 GMT

OH, You were right. as you suggested i obtained sep-06 release DVD package of HP-UX and easily could find the SAS disks.
Thanks a lot.

Re: Ignite Disk Detection on Integrity Server

ignite_ux — Tue, 23 Oct 2007 04:06:20 GMT

This Thread closed successfully :)