Problem booting vpar from Ignite SD

Lexz — Fri, 21 Sep 2007 08:49:39 GMT

Hi all,

I have this problem of which I dont know wether it is an Ignite problem or a vpar problem.
I build a vpar “test1” on an hp-ux box.
I set up an ignite server on that same vpar.
Set up a software depot from the install cd’s and added vpar software to the depot.
Build a second vpar “test2” and try to boot the new vpar from the install source using:

vparboot -p test2 -I test1,/opt/ignite/boot/Rel_B.11.23/WINSTALL

The installation looks good a first sight but ends with:

______________________________________________________________________
* Build_Kernel: Begin

* Building a new kernel using the command: "/usr/sbin/mk_kernel -f -o
/stand/vmunix".
WARNING: The configuration is supposed to include a module 'vcn' which
is not installed on the system. The system will attempt to
proceed without it, but the resulting kernel may fail to boot
or function properly.
WARNING: The configuration is supposed to include a module 'vcs' which
is not installed on the system. The system will attempt to
proceed without it, but the resulting kernel may fail to boot
or function properly.
* Building a new kernel for configuration 'import.config'...
* Adding version information to new kernel...
* /stand/system has been imported. The changes have been applied
to the currently running system.

* Build_Kernel: Complete
* Boot_From_Client_Disk: Begin
* Rebooting machine as expected.
NOTE: Rebooting system.
______________________________________________________________________

After rebooting the new vpar boot sequence stops at:

______________________________________________________________________
GenericSysName [HP Release B.11.23] (see /etc/issue)
Console Login:
[test2]
Kernel file is not relocatable for test2
File address is 0x0000000000020000 and memory address is 0x0000000010000000
Error reading program segments
Failed to load (1/0/6/0/0/4/0.0.0.0.0.0.0;)/stand/vmunix

[MON] test2 has halted.
______________________________________________________________________

What can be the problem?
Thanks for any input.

Regards,
Lex

Re: Problem booting vpar from Ignite SD

Torsten. — Fri, 21 Sep 2007 08:52:36 GMT

See this messages:

"Kernel file is not relocatable for test2"

This indicates your depot does not contain the vPar software.
Make sure you install the vPar depot along with the OS.

Re: Problem booting vpar from Ignite SD

Torsten. — Fri, 21 Sep 2007 08:54:44 GMT

See this messages:

"Kernel file is not relocatable for test2"

This indicates your depot does not contain the vPar software.
Make sure you install the vPar depot along with the OS.

=====
again error while submit :-\

See this thread, this might be your solution:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1158861

Re: Problem booting vpar from Ignite SD

Tim Nelson — Fri, 21 Sep 2007 09:20:05 GMT

Ran into the same issue way back when...

Patch issue.. Check the release notes for the vPar package.

topic Problem booting vpar from Ignite SD in Operating System - HP-UX

Problem booting vpar from Ignite SD

Re: Problem booting vpar from Ignite SD

Re: Problem booting vpar from Ignite SD

Re: Problem booting vpar from Ignite SD