topic Re: How to Change IP address on HP-UX 9000 in Operating System - HP-UX

How to Change IP address on HP-UX 9000

SSO Montgomery — Fri, 22 Feb 2002 14:07:50 GMT

What are teh necessary steps that I need to perform in able to change an IP address on an HP-UX 9000

Re: How to Change IP address on HP-UX 9000

Helen French — Fri, 22 Feb 2002 14:11:24 GMT

Hi,

Lot of ways:

1) SAM -> Network Configuration
2) Edit /etc/rc.config.d/netconf file and change IP
3) ifconfig - temperory change only
4) set_parms

HTH,
Shiju

Re: How to Change IP address on HP-UX 9000

Scott_14 — Fri, 22 Feb 2002 14:13:51 GMT

you can run set_parms,

I beleive you can also edit the /etc/rc.config.d/netconf

Re: How to Change IP address on HP-UX 9000

Patrick Wallek — Fri, 22 Feb 2002 14:14:34 GMT

# set_parms ip_address

is probably the easiest and most fool proof.

If you are using DNS also be sure to change the IP address of the system on your DNS server.

Re: How to Change IP address on HP-UX 9000

Peter Kloetgen — Fri, 22 Feb 2002 14:16:00 GMT

Hi,

the most secure way is to use SAM, he doesn't make errors.... But you could also run the command:

set_parms IP_Adress

Allways stay on the bright side of life!

Peter

Re: How to Change IP address on HP-UX 9000

George_Dodds — Fri, 22 Feb 2002 14:16:22 GMT

http://forums.itrc.hp.com/cm/QuestionAnswer/1,,0x9f880cb17a32d5118fef0090279cd0f9,00.html

Re: How to Change IP address on HP-UX 9000

Helen French — Fri, 22 Feb 2002 14:17:47 GMT

Hi,

Check this out:

http://us-support.external.hp.com/cki/bin/doc.pl/sid=65cfa4d604107cb5f2/screen=ckiDisplayDocument?docId=200000007950761

HTH,
Shiju

Re: How to Change IP address on HP-UX 9000

Edward McCouch — Fri, 22 Feb 2002 14:24:08 GMT

change it in SAM- that's the easiest way if you aren't too sure what you are doing.

I think that you can also edit the ip in the /etc/hosts file.

Re: How to Change IP address on HP-UX 9000

Sanjay_6 — Fri, 22 Feb 2002 15:24:32 GMT

Hi,

you can change the ip address of the system using sam or using /sbin/set_parms,

/sbin/set_parms ip_address

sam --> netowrking and communication --> network interface cards -->

If you do this from a workstation you may loose the connection to the server while change is effected. So it would be a good idea to do any ip address change on the server from the system console.

Hope this helps.

Regds