topic Re: problem to startup the system in Operating System - HP-UX

problem to startup the system

Alberto Hurtado — Fri, 27 Aug 2004 15:28:33 GMT

I did change the hostname with Set parameter and after that I have errors of software failure, I have tried to get up with an ignite tape and it gives me the same error
I would thank the whole help that you can lend me.

this is the error:
System name: uninitalized
Alert level 12 = Software failure
Reason for alert
Source : 1 = processor
Source Detail: 1 = proccesor general source 0 = 0
Problem Detail : 0 no problem detail
Led's run attention fault remote power
on flash flash off on

Re: problem to startup the system

Patrick Wallek — Fri, 27 Aug 2004 15:35:49 GMT

What did you try to change the name to? If it is more than 8 characters long, make it 8 characters or less.

Also, it appears to me that you are not changing the hostname itself, but changing the name within GSP which is totally separate.

Re: problem to startup the system

Mohanasundaram_1 — Sat, 28 Aug 2004 01:35:16 GMT

Hi Alberto,

You changed the hostname through "set parameter" ???

Can you explain the steps you did?

Cheers,
Mohan.

Re: problem to startup the system

Shaikh Imran — Sat, 28 Aug 2004 02:20:36 GMT

Hi Alberto Hurtado,

Could you try to boot in a single user mode?
ISL>hpux -is
Pls revert back

Regards,

Re: problem to startup the system

Kent Ostby — Sat, 28 Aug 2004 02:57:43 GMT

Alberto --

The failure you are seeing above is most likely a system panic although it could be a HW induced panic.

Try booting from :

a) a previous kernel ( hpux /stand/vmunix.prev from ISL )

b) in single user mode ( hpux -is )

c) in maintanence mode ( hpux -lm )

If these fail to work, you can unmask the "true" failure message by turning off the Alert level 12 messages as follows:

See document ID: KBRC00007966

Re: problem to startup the system

Alberto Hurtado — Mon, 30 Aug 2004 10:25:39 GMT

the problem was a card fibre PCI Channel to see some disks recently installed XP, we only retire it and normal boot it, apparently is problem of the slot or of the card.

Thanks a lot to all.

Re: problem to startup the system

anis_3 — Fri, 09 Feb 2007 08:54:49 GMT

Hi
Where could we found the document KBRC00007966
Could someone send it to me
Thanks in advance