topic Re: Getting quick started with Ignite in Operating System - HP-UX

Getting quick started with Ignite

Meir Dukhan — Wed, 22 Oct 2003 01:56:25 GMT

I need to install an Ignite server mostly for system recovery of an HPUX farm (approx 80 10.20 & 11.0, most of them 11.0).

I'm looking for a quick way to get started.

I'm already familiar with make_tape_recovery but would like to switch to Ignite server to avoid the tape administrativa and have better recovery capabilities.

I'm especially fascinated by the possibility to recover a whole system disk via network.

Thanks in advance,

-- Meir

Re: Getting quick started with Ignite

aparna challagulla — Wed, 22 Oct 2003 02:23:27 GMT

hi Meir,

go thro the software recovery handbook wherein u will find a chapter on ignite-ux.i think this is a good resource for u to get started.
http://www1.itrc.hp.com/service/iv/node.do?node=prod%2FWW_Start%2FN1%7C16%7C19

HTH
aparna

Re: Getting quick started with Ignite

T G Manikandan — Wed, 22 Oct 2003 02:59:52 GMT

check this doc

http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000066258954

you can have more information here

http://software.hp.com/products/IUX/infolib.html