topic Re: ignite backup in Operating System - HP-UX

ignite backup

CCIL — Fri, 10 Jan 2003 06:04:46 GMT

In my HP A class server the size of VG0 is 73GB . for ignite backup what should be the minimum capacity of the tape?

Re: ignite backup

Michael Tully — Fri, 10 Jan 2003 06:17:00 GMT

What type of tape facilities do you have ?

You can (if you have one) boot off a DLT8000 which you should be able to backup your ignite image to it. It has a native capacity of 40Gb and depending on compression get the 73Gb your after. You not going to know unless you test it.

Re: ignite backup

Michael Tully — Fri, 10 Jan 2003 06:30:25 GMT

Further thoughts and reading on this:

You need to look really at 'make_net_recovery'.
There are a number of postings on this.

Re: ignite backup

CCIL — Fri, 10 Jan 2003 06:49:30 GMT

I have HP sure Store DAT Drive DAT-40e I am using DDS-4 tapes of 40 GB capacity

Re: ignite backup

Wendy_9 — Fri, 10 Jan 2003 06:54:32 GMT

It depends on the tape that you use. If you use DDS tape drive, the maximum is 40G(DDS4). If you use DLT tape drive, the capacity will be up to 200G or more

Re: ignite backup

T G Manikandan — Fri, 10 Jan 2003 07:36:41 GMT

just

software.hp.com/products/IUX.

check the FAQ there

//*
What is the maximum amount of data that a make_recovery tape can hold?

A make_recovery tape can hold as much data as will fit on the tape. If make_recovery is run in the foreground it will prompt for more tapes if they are necessary. NOTE: individual files may not exceed 2GB due to a limitation in the pax command.
*//

This should not be a problem as it can spam multiple tapes.
make sure that you label them properly.

Thanks