https://community.hpe.com/t5/operating-system-hp-ux/using-ignite-to-resize-stand/m-p/2724928#M519121 The newer versions of Ignite should correct this. I highly recommend that you keep up to date on Ignite/UX anyway.<BR /><BR />The latest version is 3.6.82.<BR /><BR /><A href="http://software.hp.com/products/IUX" target="_blank">http://software.hp.com/products/IUX</A> Wed, 15 May 2002 19:57:28 GMT Patrick Wallek 2002-05-15T19:57:28Z https://community.hpe.com/t5/operating-system-hp-ux/using-ignite-to-resize-stand/m-p/2724927#M519120 I'm using an older version of ignite and found when I interrupt the recovery to change the size of /stand, the recovery does not recover all my files. My /dev/asynch driver is not recovered and my config files have been replaced with generic templates. It's like ignite thinks I'm cloning the original system.<BR /><BR />Does the later versions of ignite also exhibit this behavior? Wed, 15 May 2002 19:51:36 GMT https://community.hpe.com/t5/operating-system-hp-ux/using-ignite-to-resize-stand/m-p/2724927#M519120 Martin Johnson 2002-05-15T19:51:36Z https://community.hpe.com/t5/operating-system-hp-ux/using-ignite-to-resize-stand/m-p/2724928#M519121 The newer versions of Ignite should correct this. I highly recommend that you keep up to date on Ignite/UX anyway.<BR /><BR />The latest version is 3.6.82.<BR /><BR /><A href="http://software.hp.com/products/IUX" target="_blank">http://software.hp.com/products/IUX</A> Wed, 15 May 2002 19:57:28 GMT https://community.hpe.com/t5/operating-system-hp-ux/using-ignite-to-resize-stand/m-p/2724928#M519121 Patrick Wallek 2002-05-15T19:57:28Z