topic Re: Cannot see CPU on npar in Operating System - HP-UX

Cannot see CPU on npar

Janet Sanberg — Tue, 06 Jul 2010 17:31:02 GMT

I have an rp7420 which is npar'd 2 ways. On each cell there are 4 dual core CPU's - but when I do a parstatus I can only see 3:

[Cell]
CPU Memory Use
OK/ (GB) Core On
Hardware Actual Deconf/ OK/ Cell Next Par
Location Usage Max Deconf Connected To Capable Boot Num
========== ============ ======= ========= =================== ======= ==== ===
cab0,cell0 active core 6/0/8 16.0/ 0.0 cab0,bay0,chassis0 yes yes 1
cab0,cell1 active core 6/0/8 16.0/ 0.0 cab0,bay0,chassis1 yes yes 0

How do I get it to recognize the last CPU (so it will read 8/0/8). The CPU is physically there (I've looked directly at the cell).

Also at the CM, then I do a PS, I see:

CPU Module Slot 0 1 2 3
Populated P P P
Local 48V Good * * *
Power Enabled * * *
Power Good * * *

But again, the 4th dual core is physically there. Both npars have this issue so I do not think it is bad hardware, must be configuration?

Re: Cannot see CPU on npar

S.N.S — Tue, 06 Jul 2010 17:42:05 GMT

Hi Janet,

Any specific issues - like abrupt shutdown/power failure - before this happened?

What does the MP > SEL logs Show - any 'Alerts'?

HTH out,
SNS

Re: Cannot see CPU on npar

Torsten. — Tue, 06 Jul 2010 17:43:22 GMT

What is the result of this?

# icapstatus

Re: Cannot see CPU on npar

Janet Sanberg — Tue, 06 Jul 2010 17:44:19 GMT

No everything is clean and green. I have another machine that is configured like this on both npars as well, which is why I think it is configuration and not hardware issue.

Re: Cannot see CPU on npar

Janet Sanberg — Tue, 06 Jul 2010 17:47:31 GMT

# icapstatus
sh: icapstatus: not found.
# which icapstatus
no icapstatus in /usr/bin /usr/sbin /sbin .

Re: Cannot see CPU on npar

Deeos — Sun, 11 Jul 2010 11:34:32 GMT

hi,

can you share with me

#parstatus -V

Regards
Deeos

Re: Cannot see CPU on npar

Janet Sanberg — Mon, 12 Jul 2010 10:42:55 GMT

Deeos -thank you for your replay. This has been resolved, I will close the thread. thanks!!

Re: Cannot see CPU on npar

Janet Sanberg — Mon, 12 Jul 2010 10:43:42 GMT

Thank you for your replies.

Re: Cannot see CPU on npar

Torsten. — Mon, 12 Jul 2010 10:46:52 GMT

" This has been resolved,..."

We all would like to know how this was solved ...

;-)