topic Trouble Installing New BIND Release in Operating System - HP-UX

Trouble Installing New BIND Release

Tommy Brown — Wed, 24 Jun 2009 14:21:18 GMT

I am trying to install the new HP BIND release on my rx1620. I get the attached error when I attempt:

I am currently running:
DNSUPGRADE C.9.3.2.1.0 BIND UPGRADE
Thanks,
Tommy

Re: Trouble Installing New BIND Release

Steven E. Protter — Wed, 24 Jun 2009 14:32:26 GMT

Shalom,

You are missing pre-requisites.

This could be patches.

It could be the previous version of BIND. This is an upgrade pack and you might need to install the original package first.

swlist -l product | grep -i bind

SEP

Re: Trouble Installing New BIND Release

Tommy Brown — Wed, 24 Jun 2009 14:35:42 GMT

Thanks Stephen,

[omnisrvr] (root) swlist -l product | grep -i bind
BindUpgrade C.9.3.2.1.0 BIND special release upgrade
PHNE_34226 1.0 Bind 9.2.0 components
PHNE_37865 1.0 Bind 9.2.0 components

This is what I have now, I cannot identify the pre-req.
I must be blind and brain-dead today.
Tommy

Re: Trouble Installing New BIND Release

Tommy Brown — Wed, 24 Jun 2009 14:47:17 GMT

I am not sure, I cannot identify the product INETSVCS I tried installing PHNE_34107, it is already installed, but gives the same error regarding the INETSVCS2-RUN..
I cannot locate that package on HP's SW Depot.
Tommy

Re: Trouble Installing New BIND Release

rick jones — Wed, 24 Jun 2009 23:33:37 GMT

My take on the attachement is that these:

The prerequisite
"PHNE_36219.INETSVCS-RUN,fr=1.0,fa=HP-UX_B.11.23_IA/PA" for fileset "BindUpgrade.BIND-UPGRADE,r=C.9.3.2.4.0" cannot be successfully resolved.

The prerequisite "PHNE_36219.INETSVCS2-RUN,fr=1.0,fa=HP-UX_B.11.23_IA | PHNE_36219.INETSVCS2-RUN,fr=1.0,fa=HP-UX_B.11.23_PA" for fileset "BindUpgrade.BIND-UPGRADE,r=C.9.3.2.4.0" cannot be successfully resolved.

The corequisite
"PHNE_36219.INETSVCS2-RUN,fr=1.0,fa=HP-UX_B.11.23_IA" for fileset "BindUpgrade.BIND-UPGRADE,r=C.9.3.2.4.0" cannot be successfully resolved.

a corequisite is something that needs to be there at the same time as you install vs already being installed. Perhaps there is some confusion in the scripts.

are the bits you are missing.

Re: Trouble Installing New BIND Release

Tommy Brown — Thu, 25 Jun 2009 11:47:01 GMT

Thanks Rick, I have tested and found that my Secondary DNS will accept the upgrade. I found a previous thread that the authors success was built on Re-installing INETSVCS and then reinstalling the Q-Patch bundle and the BINDUPGRADE. I am not sure I am quite ready for all that at the moment. I am weighing what will happen if I remove the prior DNSUPGRADE bundle and applied the new one. I would probably have to wait until my scheduled maintenance day on July 13 to try that.
Tommy