topic Re: cannot add IP address in Operating System - HP-UX

cannot add IP address

Sandy Chen — Fri, 20 Jan 2006 06:06:22 GMT

Hi all,

I wanted to add IP address on my system
existing is 192.168.125.7, 255.255.255.0

default gateway is 192.168.125.1

I wanted to add 10.10.10.7, 255.0.0.0

The addition is on different NIC
everytime I add the second IP all network is not accessible from everywhere but if I changed the subnet of the NEW IP to class C it works just fine

any idea??

regards,
Chen

Re: cannot add IP address

Arunvijai_4 — Fri, 20 Jan 2006 06:10:29 GMT

Hi Chen,

This could be a routing problem since you added another IP to your host(NIC). What is your /etc/resolv.conf ? and /etc/nsswitch.conf ?

-Arun

Re: cannot add IP address

Devender Khatana — Fri, 20 Jan 2006 06:10:37 GMT

Hi,

After adding another IP and different subnet are you defining any gateway between the two networks configured on the same host or the routing part taken care by something else?

Is your original IP also not available or only new one? If only new one is not available I would doubt the subnet of other devices in your network. It should be matching with the one you are setting on for the devices to communicate.

HTH,
Devender

Re: cannot add IP address

Sandy Chen — Fri, 20 Jan 2006 06:30:27 GMT

Hi,

After adding the second IP with subnet class A, all IP is not accessible, including the first IP.

For the second IP actually I don't have any gateway cause I meant it to connect only to a few servers through a dedicated switch.

regards,
Chen

Re: cannot add IP address

Ivan Ferreira — Fri, 20 Jan 2006 07:15:11 GMT

After you add the IP to the second nic, can you please post the output of:

netstat -nr
netstat -ni

You can post the results in the two situations, when you use Class A mask and Class C mask.

Re: cannot add IP address

rmueller58 — Mon, 23 Jan 2006 09:21:17 GMT

You will need to define the gateway address on the secondary IP as well, It will require a secondary address on the router that is acting as the gateway.

Routing 10.xxx numbers can be handled without a statically mapped gateway on the server but defining a supernet on the routers..

Contact your Router guy, or check with your vendor.
10.xxx numbers are private numbers and cannot be broadcast, to the "I"nternet. You will need a NAT (network address translation) address as well defined on the router if you wish the 10.xxx address to see the outside world.

Re: cannot add IP address

Indrajit_1 — Fri, 27 Jan 2006 09:35:30 GMT

Hi;

It is because of default gateway. u no need to make any changes in ur hp unix box. u just need to enter one more route in ur router (cisco , etc). if cisco router, u need to made an entry ..

#config t
#router rip
#network 10.0.0.0
Ctrl Z
#copy run start

Now machine will accessible from other network.

Hope this will help u to resolve ur issue

cheers
indrajit