topic Re: Console Message???? in Operating System - HP-UX

Console Message????

mark.M — Thu, 26 Jan 2006 01:10:12 GMT

i has rx5670 server.
when i'm find dumy console message on server.
what is it?

**********100Mb/s PCI LAN/9000 Networking

Thu Jan 26 kst 2006 09:20:31 632416 DISASTER Subsys=PCI100BT

Loc:00000 <6001> HPPCI100 10/100BASE-T driver detected bad cable connection between

the adapter in slot land the hub or switch

Re: Console Message????

Kasper Hedensted — Thu, 26 Jan 2006 02:16:35 GMT

Hi Mark,

Last time I saw this error, it was due to a bad cable.

Cheers,
Kasper

Re: Console Message????

Peter Godron — Thu, 26 Jan 2006 03:37:26 GMT

Mark,
please check your network cable.
Probably worth swapping it.

Re: Console Message????

Torsten. — Thu, 26 Jan 2006 05:03:25 GMT

The physical connection between the network card and the switch is lost (bad/removed cable?). Please check this.

Re: Console Message????

Chauhan Amit — Fri, 27 Jan 2006 03:31:01 GMT

This message can come due to following reasons:

a) Bad Cable
b) Port fault on Hub/Switch
c) Faulty Hub/Switch

You can pin point the fault by checking other systems connected to the same Hub/Switch. If all systems are getting above message,most probably Switch issue. Switch reboot may also cause this message.

Regards,
Amit Chauhan

Re: Console Message????

Darrel Louis — Fri, 27 Jan 2006 03:35:35 GMT

Mark

Do you've STM installed on your server?
Check with STM if you can get more info, also if STM is installed you should see messages in your syslog.log file.

Does dmesg give you any messages?

Darrel

Re: Console Message????

Muthukumar_5 — Fri, 27 Jan 2006 03:42:33 GMT

Refer this:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=717809

--
Muthu

Re: Console Message????

Devender Khatana — Fri, 27 Jan 2006 07:07:38 GMT

Hi,

It could be due to

1. Bad cable
2. Bad port
3. Link up/down for some time.

Is the problem repeating or came only once?

HTH,
Devender

Re: Console Message????

Peter Godron — Mon, 06 Feb 2006 08:51:45 GMT

Mark,
have you got an update on this?
If the problem is fixed, please identify the solution, award points and close.