lanadmin -X

Nuwan Wijesundera — Tue, 18 Dec 2012 06:30:13 GMT

I need to clarify a doubt regarding the lanadmin command.
There is a HSC 100 base T Single port lan adapter attached to a D-Class server with HP-UX 10.20 installed.Currently this adapter is running at 10Mbps and half duplex mode.
I want to change this to 100Mbps and to full duplex mode.
I know this is possible with lanadmin command, but I want to know whether system required a reboot after the change these modes.
Because this system is online system and need to be keep on minimum downtime.
Thanks
Nuwan

P.S. this thread has been moved from Disk, Disk Arrays (Legacy) to HP-UX > networking - HP Forums Moderator

Re: lanadmin -X

CA328608 — Fri, 27 Dec 2002 15:13:18 GMT

Nuwan,

I've never had much luck running lanadmin -X on a 10.20 machine. It doesn't seem to have the desired effect.

Check /etc/rc.config.d/hpbase100conf. You can set the following:
HP_BASE100_SPEED=100
HP_BASE100_DUPLEX=full

On the next reboot, the card will operate at 100 Full.

On a related note, make SURE your switch supports 100F and is NOT set to autonegotiate.

Regards,
Mark

topic Re: lanadmin -X in Operating System - HP-UX

lanadmin -X

Re: lanadmin -X