GSP

lastgreatone — Thu, 10 May 2001 14:39:15 GMT

I do not have the GSP configured on a Lan port but I have the ATTN amber flashing light on all the time. Should I be concerned?

Re: GSP

Sprint Unix Team — Thu, 10 May 2001 14:45:29 GMT

may be you have to log in to the GSP through the console and acknowledge all messages.

When there is a abrupt shutdown due to power failure or any critcal failures causes the light to flash.

If this solved your problem, please assign points

Re: GSP

Victor BERRIDGE — Thu, 10 May 2001 14:46:02 GMT

Hi,
Just to make sure, I would connect GSP:
At the console type
CTRL-B then at the prompt type SL, to see what is logged: e, and to leave quit =q
and co to return at the console...

All the best
Victor

Re: GSP

Vincenzo Restuccia — Thu, 10 May 2001 14:57:32 GMT

If you want show log of GSP with Accessing Guardian Service Processor Internal Port:

The Guardian Service Processor (GSP) internal port can be used as a "back door" to reset
security options in case the GSP administrator password is forgotten, for example. It can
also be used in order to upgrade the GSP firmware from an HP-UX session. The internal
port needs to be configured in order to use it.
1. On the system, the GSP internal port should be /dev/tty1p0.
2. SAM does not configure the GSP internal port.
3. If the device file is not present, it can be created as follows:
#cd/dev
#mknod tty1p0 c 1 0x010000
4. Since this allows unrestricted access to the GSP and bypasses GSP security features (no
user or password required). Make sure to delete this device file when you have finished
using it.
5. The internal port can be accessed via terminal emulators such as cu. To use cu, you
need the follow entries (the entries must be exactly as shown):
/usr/lib/uucp/Systems needs the following entry:
gspiport Any;5 gspiport,f900 - ''''\r\d\r\d\r ogin:-BREAK-ogin:
uucp asswrd: uucp-BREAK-ogin: uucp asswrd: uucp
The spelling looks unusual, but it needs to be exactly as shown.
/usr/lib/uucp/Devices needs the following entry:
gspiport tty1p0 - 9600 direct
6. when all of the configuration is done, you should be able to access the GSP internal port
with the cu command:
cu-1/dev/tty1p0
7. To terminate the cu session, use "~." [return]
8. Kermit can also be used to access the special device file. See the kermit web pages for
details.
CAUTION Securing the /dev/tty1p0 device file with root capabilities will not prevent
non-root users from accessing the GSP internal port. This is due to the fact
that cu and kermit carry root access and run with the sticky bit enabled.
To secure the internal port from unauthorized use, be sure to remove the
/dev/tty1p0 file after using it.

topic Re: GSP in Operating System - HP-UX

GSP

Re: GSP

Re: GSP

Re: GSP