topic Re: pax in Operating System - HP-UX

pax

Allanm — Mon, 11 Aug 2008 21:16:36 GMT

Hi Gurus,

I need to restart the copy through the pax command from where it got left out since the drive to which I was copying to got unmounted accidentally.

When I tried my usual way -

pax -rw

pax: Unable to remove directory ...

Thanks,
Allan

Re: pax

Dennis Handly — Sun, 11 Sep 2011 12:48:32 GMT

>pax: Unable to remove directory ...

You may have to remove it first.

Re: pax

James R. Ferguson — Mon, 11 Aug 2008 21:31:11 GMT

Hi Allan:

The 'pax' utility does not have restart point capability. Empty the destination directory and restart your copy.

Regards!

...JRF...

Re: pax

Allanm — Mon, 11 Aug 2008 21:37:15 GMT

Thanks for replying so quickly, any other alternate command which can do that for me instead of deleting the previously copied stuff.

Please share.

Thanks,
Allan.

Re: pax

James R. Ferguson — Mon, 11 Aug 2008 21:42:46 GMT

Hi (again) Allan:

> any other alternate command which can do that for me instead of deleting the previously copied stuff.

I suppose that you could add the '-u' switch to your copy (see the 'pax' manpages). I am not sure that this is going to gain you any speed when compared to deleting everything copied thus far and beginning again, though.

Regards!

...JRF...

Re: pax

Dennis Handly — Mon, 11 Aug 2008 21:45:09 GMT

>any other alternate command which can do that for me instead of deleting the previously copied stuff.

It may take longer to do the mickey mouse commands than to restart. It's already been 11+ minutes.

If you want to "restart", you'll need to invoke pax(1) in a subtree and redo for each directory that wasn't copied. And if you have a partial copy, you'll need to remove and restart.

Much safer to redo everything, unless you think doing a dircmp(1) is faster.