https://community.hpe.com/t5/operating-system-hp-ux/openssh-3-4p1/m-p/2833673#M754850 Did you compile with PAM support enabled? If you're not utilizing PAM, you might want to try recompiling without the --with-pam configure option. I've had problems with OpenSSH and PAM even on non-tsconverted systems. -Tim Mon, 28 Oct 2002 18:17:33 GMT Tim Maletic 2002-10-28T18:17:33Z https://community.hpe.com/t5/operating-system-hp-ux/openssh-3-4p1/m-p/2833671#M754848 I have installed openssh 3.4p1. After starting the sshd, I tried to connect to the server from client. However, when I finished entering password, the connection was closed. <BR />This is the error from syslog: <BR />sshd[12591]: fatal: PAM session setup failed[33]: General Commercial Security error<BR />sshd[12589]: Could not reverse map address IP<BR />Thanks Fri, 25 Oct 2002 18:53:47 GMT https://community.hpe.com/t5/operating-system-hp-ux/openssh-3-4p1/m-p/2833671#M754848 castro_2 2002-10-25T18:53:47Z https://community.hpe.com/t5/operating-system-hp-ux/openssh-3-4p1/m-p/2833672#M754849 It's working. Thanks<BR />I have openssh 3.4p1 and HP Trusted system.<BR /><BR />vi sshd_confi<BR />UsePrivilegeSeparation no<BR />restart ssh<BR /> Fri, 25 Oct 2002 19:50:03 GMT https://community.hpe.com/t5/operating-system-hp-ux/openssh-3-4p1/m-p/2833672#M754849 castro_2 2002-10-25T19:50:03Z https://community.hpe.com/t5/operating-system-hp-ux/openssh-3-4p1/m-p/2833673#M754850 Did you compile with PAM support enabled? If you're not utilizing PAM, you might want to try recompiling without the --with-pam configure option. I've had problems with OpenSSH and PAM even on non-tsconverted systems. -Tim Mon, 28 Oct 2002 18:17:33 GMT https://community.hpe.com/t5/operating-system-hp-ux/openssh-3-4p1/m-p/2833673#M754850 Tim Maletic 2002-10-28T18:17:33Z