https://community.hpe.com/t5/operating-system-hp-ux/slp-problem/m-p/2419806#M766349 I am facing a problem with "slp"command in hpux 10.20<BR />running on HP 9000 D230 server.<BR />When I issue the command <BR />slp -c80 -i0 -n &gt;/dev/c2t0d0_lp<BR />it gives an error <BR />"slp: error -- stdout is not a printer!"<BR /> with the same os In G30 server this command<BR /> works fine.<BR /> Does anyone know the solution for this problem.<BR /> Thu, 16 Mar 2000 03:45:38 GMT Raju Mahendran 2000-03-16T03:45:38Z https://community.hpe.com/t5/operating-system-hp-ux/slp-problem/m-p/2419806#M766349 I am facing a problem with "slp"command in hpux 10.20<BR />running on HP 9000 D230 server.<BR />When I issue the command <BR />slp -c80 -i0 -n &gt;/dev/c2t0d0_lp<BR />it gives an error <BR />"slp: error -- stdout is not a printer!"<BR /> with the same os In G30 server this command<BR /> works fine.<BR /> Does anyone know the solution for this problem.<BR /> Thu, 16 Mar 2000 03:45:38 GMT https://community.hpe.com/t5/operating-system-hp-ux/slp-problem/m-p/2419806#M766349 Raju Mahendran 2000-03-16T03:45:38Z https://community.hpe.com/t5/operating-system-hp-ux/slp-problem/m-p/2419807#M766350 The slp commmand was designed for use with the lpr2 driver only. This driver is <BR />not used on the D-class as it is for a parallel driver and card, that is not <BR />supported in a D-class. The parallel interface driver on the D-class uses the <BR />CentIf driver.<BR /><BR />I believe you can achieve the same result by editing the printer interface <BR />script and add in the line:<BR />lmargin=0<BR /><BR />HTH Thu, 16 Mar 2000 04:07:40 GMT https://community.hpe.com/t5/operating-system-hp-ux/slp-problem/m-p/2419807#M766350 Melvyn Burnard_1 2000-03-16T04:07:40Z