topic Re: Table is full in Operating System - HP-UX

Table is full

Valkiria Santos — Fri, 02 Aug 2002 10:11:03 GMT

Hi guys,

I??d like to know wath kernel parameter I need set to message vmunix: kthread: table is full.
Nproc? Ninod? Nfile? other one? I??ve oracle 8i anda Sybase 12 in the same machine.
My o.s is 11.11.

Thanks,
Valkiria

Thanks

Re: Table is full

Pete Randall — Fri, 02 Aug 2002 10:12:51 GMT

Valkiria,

Do you have Glance installed? If so, you can check the system tables report and it should point you to the right parameter.

Pete

Re: Table is full

Bill McNAMARA_1 — Fri, 02 Aug 2002 10:19:11 GMT

nkthread

post up the results of sysdef.

Later,
Bill

Re: Table is full

Valkiria Santos — Fri, 02 Aug 2002 10:20:06 GMT

avail used %used
nproc -276 123 45
nfile- 920 511 56

This is my values, how much you recomend to add, 30%, 50%?
In 11.11 version, this parameters reboot the system?

Re: Table is full

Valkiria Santos — Fri, 02 Aug 2002 10:22:12 GMT

Look sysdef output.

Re: Table is full

Pete Randall — Fri, 02 Aug 2002 10:26:59 GMT

Valkiria,

They're pretty low. Not really knowing anything about your system I would say you could easily double them. Using SAM to increase maxusers should accomplish this since maxusers is used in the formulas for both these parameters.

HTH,
Pete

Re: Table is full

Trond Haugen — Fri, 02 Aug 2002 10:48:56 GMT

You would want to increase the parameter 'nkthread'.

Regards,
Trond

Re: Table is full

Valkiria Santos — Fri, 02 Aug 2002 10:58:34 GMT

Tony,

I not found this parameter.
Valkiria

Re: Table is full

Pete Randall — Fri, 02 Aug 2002 10:58:56 GMT

Very good, Trond. I didn't connect kthread with nkthread. Using SAM to increase maxusers will also bump up nkthread thanks to the formulas.

Pete