topic RPC: Program not registered in Operating System - HP-UX

RPC: Program not registered

Gary Cooper_1 — Thu, 19 Jan 2006 04:23:03 GMT

I'm getting the following message in syslog (on computer uxhome2):

uxhome2 syslog: libtt[16957]: clnt_create for rpc.ttdbserverd on pic2025 failed: RPC: Program not registered

It is repeated 5 times each day at around 8:00 a.m. This would correspond with a cron job that runs on uxhome2 and which does a remsh onto pic2025 to check a couple of log files. The same script also checks the log files on other machines, but no corresponding messages are logged.

Note that when I do a ps -ef | grep ttdb, rpc.ttdbserver is not running.

Any help would be much appreciated.

Thanks,

Gary

Re: RPC: Program not registered

Sivakumar TS — Thu, 19 Jan 2006 04:27:29 GMT

Hi,

Check this,

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=194435&admit=-682735245+1137662807009+28353475

With Regards,

Siva.

Re: RPC: Program not registered

Arunvijai_4 — Thu, 19 Jan 2006 04:29:42 GMT

Hello Gary,

Check this thread as well,

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=29607

-Arun

Re: RPC: Program not registered

RAC_1 — Thu, 19 Jan 2006 04:37:33 GMT

This could be rpc tooltalk daemon. Check if it is runnning or not. ps -ef| grep -i rpc

You can restart it from /sbin/init.d/. It is named as something like rpc.ttdb*

Also check rpcinfo -p pic2025 And see if something like tooltalk is listed there or not.

Re: RPC: Program not registered

Gary Cooper_1 — Thu, 19 Jan 2006 04:57:21 GMT

Thanks for the responses.

I was rather hoping for something other than ignore the message.

rpc.ttdbserverd is not running - I was advised by HP support to disable it some time back.

Regards,

Gary