topic Re: The led flash in Operating System - HP-UX

The led flash

O'lnes — Thu, 12 Sep 2002 09:37:00 GMT

After we boot up our HP UNIX machine , the 'attn' and 'fault' led flash , how to reset the led? Thanks.

Re: The led flash

Pete Randall — Thu, 12 Sep 2002 09:45:05 GMT

Go into the Guardian Server Process by doing b at the console. Hit enter at the login and password prompts (assuming they'be never been set). Then type in sl (for show logs), e (for error), n (for no filter), review any errors to see if action is required, then type q (for quit) and co (to return to console mode). Your LED's should stop flashing.

Pete

Re: The led flash

Bill McNAMARA_1 — Thu, 12 Sep 2002 09:59:04 GMT

If you're generally not bothered about why leds flash, you can always remove them!

This is going to happen on every reboot/shutdown.

Later,
Bill

Re: The led flash

T G Manikandan — Thu, 12 Sep 2002 10:37:21 GMT

If the attention led flashes it has got some information messages not very critical but it is good looking at the logs.
If your fault LED is flashing the red one,then there is some major fault on the machine.

Yes, you can go into the GSP by pressing cntl-B

then
doing a
GSP>sl
and watching the logs there.

Thanks