https://community.hpe.com/t5/operating-system-hp-ux/progamming-with-scsi-commands/m-p/2496898#M830377 Does anyone have some sample code they're willing to share that deals with scsi commands. I have a sony AIT-2 tape drive - where I am writing some code to read the logfile on board the tape drive. Well, to do this - I have to open the device, and setup the commands to do the LOG SELECT and LOG SENSE scsi commands. I don't quite have enuf scsi programming experience to pull this together. <BR /><BR />thanks in advance,<BR /><BR />Ken Hunter :)<BR /> Wed, 21 Feb 2001 21:08:54 GMT Ken Hunter 2001-02-21T21:08:54Z https://community.hpe.com/t5/operating-system-hp-ux/progamming-with-scsi-commands/m-p/2496898#M830377 Does anyone have some sample code they're willing to share that deals with scsi commands. I have a sony AIT-2 tape drive - where I am writing some code to read the logfile on board the tape drive. Well, to do this - I have to open the device, and setup the commands to do the LOG SELECT and LOG SENSE scsi commands. I don't quite have enuf scsi programming experience to pull this together. <BR /><BR />thanks in advance,<BR /><BR />Ken Hunter :)<BR /> Wed, 21 Feb 2001 21:08:54 GMT https://community.hpe.com/t5/operating-system-hp-ux/progamming-with-scsi-commands/m-p/2496898#M830377 Ken Hunter 2001-02-21T21:08:54Z https://community.hpe.com/t5/operating-system-hp-ux/progamming-with-scsi-commands/m-p/2496899#M830378 Pardon me for asking, but.............<BR /><BR />I can use STM to strip the logs from disk files and while I've never needed to do that for a tape drive perhaps it is possible? This would avoid the need to write code. Wed, 21 Feb 2001 21:20:19 GMT https://community.hpe.com/t5/operating-system-hp-ux/progamming-with-scsi-commands/m-p/2496899#M830378 paul courry 2001-02-21T21:20:19Z