topic samba in Operating System - HP-UX

samba

Jeffrey F. Goldsmith — Thu, 23 Sep 2004 13:01:18 GMT

I am trying to install samba 3.0.2a on my HP-UX 11.i server. When I ran swinstall and try to do the install I get the following error. Anyone know what this means and how to fix it?

The corequisite "ncurses.ncurses-SHLIBS" for fileset "samba.samba-RUN,r=3.0.2a" cannot be successfully resolved.

Thanks for the help.

Re: samba

RAC_1 — Thu, 23 Sep 2004 13:08:36 GMT

As the error message says, you do not have ncurces loaded onto the system. Load them first.

Anil

Re: samba

Jeffrey F. Goldsmith — Thu, 23 Sep 2004 13:28:53 GMT

Thanks for the insight about needing to install ncurses. I was able to find the file and get it installed. Next I installed samba 3.0.2 onto my server without any problems.
Now, with my next question should I open a new question or ask it here?

Now that samba has been installed on my server where would it be located so I can get it working?

Re: samba

eric roseme — Thu, 23 Sep 2004 13:37:41 GMT

If you are using HP CIFS/Samba TP, then the binaries are in /opt/samba/bin, the config files in /etc/opt/samba, and various data files under /var/opt/samba. In this case, go back to the software.hp.com website and get the current TP that is 3.0.5.

If you are using opensource Samba, then everything is in /usr/local/samba. In this case, you should get our HP-UX 3.0.5 binaries off off samba.org.

If you are on CIFS/Samba, then go to www.docs.hp.com and get the CIFS admin guide and release notes. If you are using Opensource, then get "The Offical Samba-3".

Eric Roseme

Re: samba

RAC_1 — Thu, 23 Sep 2004 13:45:13 GMT

It would be under /opt/samba.

To start it.
/sbin/init.d/samba
The config file /etc/opt/samba/smb.conf.

Also read the following documents. A good guide on Samba.

http://www.oreilly.com/catalog/samba/chapter/book

Re: samba

Jeffrey F. Goldsmith — Thu, 23 Sep 2004 17:00:16 GMT

Thanks for the help. I was able to locate the correct file and now I have one more question. last month I installed samba 2.2.8a on my server and now I want to install samba 3.0.5. Do I just do an swremove on the old version and then do an swinstall on the new version?

Re: samba

Jeffrey F. Goldsmith — Thu, 23 Sep 2004 17:58:57 GMT

With everyons help I was able to find the file I needed and got it downloaded.