topic Re: HP-UX 11.0 in Operating System - HP-UX

HP-UX 11.0

Andrew_234 — Tue, 03 Aug 2004 13:23:37 GMT

How do I convert back to a non-trusted system?
Will this mess things up on the system.

Thanks Andrew

Re: HP-UX 11.0

Jeff Schussele — Tue, 03 Aug 2004 13:27:24 GMT

Hi Andrew,

/usr/lbin/tsconvert -r

And no, it shouldn't.

Rgds,
Jeff

Re: HP-UX 11.0

Patrick Wallek — Tue, 03 Aug 2004 13:28:50 GMT

To convert to non-trusted --

# /usr/lbin/tsconvert -r

No this should not mess anything up. You should just wind up with the encrypted passwords back in the /etc/password file.

Re: HP-UX 11.0

Bharat Katkar — Tue, 03 Aug 2004 13:31:18 GMT

HI,
"/usr/lbin/tsconvert -r" is the command to revert back. Take a look at doc attached.
Regards,

Re: HP-UX 11.0

Andrew_234 — Tue, 03 Aug 2004 13:31:30 GMT

Do people have to be logged off the system?
Will the reset the passwords?

Thanks Andrew

Re: HP-UX 11.0

Jeff Schussele — Tue, 03 Aug 2004 13:33:34 GMT

Hi (again) Andrew

No & no.

Rgds,
Jeff

Re: HP-UX 11.0

Patrick Wallek — Tue, 03 Aug 2004 13:34:29 GMT

No it will not reset passwords, only converting TO trusted will expire passwords.

I don't think users have to be logged off, but I would do it when there are as few as possible logged on.

Re: HP-UX 11.0

Andrew_234 — Tue, 03 Aug 2004 14:07:56 GMT

The /usr/lbin/tsconvert-r does not work.
Any idea???

Andrew

Re: HP-UX 11.0

Jeff_Traigle — Tue, 03 Aug 2004 14:18:53 GMT

What's the error? Granted I haven't done it a lot, but the only problem I've run into was converting to Trusted System due to majorly invalid username entries. COnverting back to untrusted is pretty smooth.

Re: HP-UX 11.0

Andrew_234 — Tue, 03 Aug 2004 14:29:00 GMT

The error is
sh: /usr/lbin/tsconvert-r

Re: HP-UX 11.0

Robert-Jan Goossens — Tue, 03 Aug 2004 14:36:22 GMT

Hi Andrew,

Is there a space between tsconvert and the -r ?

# /usr/lbin/tsconvert -r

Regards,
Robert-Jan

Re: HP-UX 11.0

Bharat Katkar — Tue, 03 Aug 2004 14:41:05 GMT

Andrew,
# /usr/lbin/tsconvert -r

Use space between tsconvert and -r. -r is the switch to the command tsconvert. That works.

Regards,

Re: HP-UX 11.0

Emil Velez — Wed, 04 Aug 2004 06:48:04 GMT

In the menu of sam that converted the system you can actually unconvert the system in sam. I recommend that since it will be logged when it was done and it will be done successfully.