topic Re: 11i Sept 2001 Document Error in Operating System - HP-UX

11i Sept 2001 Document Error

Ken Martin_3 — Wed, 12 Dec 2001 17:58:21 GMT

FYI

The manual that comes with 11i Sept 2001 "HP-UX 11i installation and update guide" has an error on page 34 (Back Up Your System).

Paragraph "Using make_tape_recovery makes reference to a 'C' option "-ACv". There is no 'C' option. On the next page it makes the same reference to 'C'.

Ken

Re: 11i Sept 2001 Document Error

Helen French — Wed, 12 Dec 2001 18:06:35 GMT

hey,

Not sure about the document. But the 'C' option normally use for creating the system status file - /var/opt/ignite/recovery/makrec.last

HTH,
Shiju

Re: 11i Sept 2001 Document Error

James R. Ferguson — Wed, 12 Dec 2001 18:11:57 GMT

Hi Ken:

# make_tape_recovery -x inc_entire=vg00 -I -v -a /dev/rmt/0mn

...will create an Ignite recovery tape for all of vg00

Regards!

...JRF...

Re: 11i Sept 2001 Document Error

Eileen Millen — Wed, 12 Dec 2001 18:16:07 GMT

C was an option with the older versions of Ignite. The Merging make_*recovery document that I got at Interex, still mentions -C.
It says that it adds checksum information for the check recovery.
The latest version of Ignite are the best.
We are using 3.3.
Eileen

Re: 11i Sept 2001 Document Error

Ken Martin_3 — Wed, 12 Dec 2001 18:44:36 GMT

Thanks for the info. Just trying to help out.

That brings up another unresolved problem with Ignite-UX. Reference message: http://forums.itrc.hp.com/cm/QuestionAnswer/1,,0xbf43a22831ebd5118ff40090279cd0f9,00.html

Last status. I reinstalled 11i Sept 2001. No good. Am now installing 11i June 2001.

Problem is tape creates OK using commands:
make_tape_recovery -ACv -a /dev/rmt/0mn

When trying to boot from tape after doing a sea then bo p1 I get the messages:

Booting...
Boot IO Dependent Code (IODC) revision 150
Failed I/O operation
ENTRY_IO
Status = -5

Followed by 4 lines of Hex codes

Error Reading IPL

Could not find any explanation of codes!

Then boot menu appears

The machine is a 9000/778/B132L

The machine seems to run fine other then Ignite and LP printing. Don't know if it matters the B132L has an 18.3GB SCSI drive.

The version of Ignite appears to be B.3.4.11.5

I am trying to do prep and testing on the B132 before upgrading a D270 and a D330 server. Not too happy so far.

Any ideas?

P.S. Another problem exists now that the B132 is on 11i. I can't print locally. lp spooler says can't open device. See message: http://forums.itrc.hp.com/cm/QuestionAnswer/1,,0x123ba22831ebd5118ff40090279cd0f9,00.html printing under 10.20 worked fine!

Ken