https://community.hpe.com/t5/operating-system-linux/cd-writer-8200i-on-linux-mandrake-9-0/m-p/2830211#M2780 Hello,<BR /><BR />At LILO prompt, try :<BR /><BR />linux hdd=ide-scsi<BR /><BR />If it works, edit /etc/lilo.conf and add :<BR /><BR />append="hdd=ide-scsi".<BR /><BR />With Linux, you will then use /dev/scd0 instead of /dev/hdd.<BR /><BR />Good luck.<BR /><BR />Kodjo<BR /> Tue, 22 Oct 2002 20:38:01 GMT Kodjo Agbenu 2002-10-22T20:38:01Z https://community.hpe.com/t5/operating-system-linux/cd-writer-8200i-on-linux-mandrake-9-0/m-p/2830210#M2779 Hello World.<BR />When installing Linux Mandrake 9.0 on my PC the installation stops at the last prompt when loading Linux.<BR />I disconnected my 8200i from the Second IDE Slave and it runs.<BR />When connecting the 8200i again Linux stops booting at the last prompt.<BR />The hardware is OK under Win 98SE if the bus speed to the 8200i is reduced. I tried to choke the bus speed even more without success.<BR />Any tips? Mon, 21 Oct 2002 18:47:34 GMT https://community.hpe.com/t5/operating-system-linux/cd-writer-8200i-on-linux-mandrake-9-0/m-p/2830210#M2779 Mats Kjernsby 2002-10-21T18:47:34Z https://community.hpe.com/t5/operating-system-linux/cd-writer-8200i-on-linux-mandrake-9-0/m-p/2830211#M2780 Hello,<BR /><BR />At LILO prompt, try :<BR /><BR />linux hdd=ide-scsi<BR /><BR />If it works, edit /etc/lilo.conf and add :<BR /><BR />append="hdd=ide-scsi".<BR /><BR />With Linux, you will then use /dev/scd0 instead of /dev/hdd.<BR /><BR />Good luck.<BR /><BR />Kodjo<BR /> Tue, 22 Oct 2002 20:38:01 GMT https://community.hpe.com/t5/operating-system-linux/cd-writer-8200i-on-linux-mandrake-9-0/m-p/2830211#M2780 Kodjo Agbenu 2002-10-22T20:38:01Z