https://community.hpe.com/t5/operating-system-linux/command-for-virtual-config/m-p/4705887#M42578 Can you post the output of "pd all show" from hpacucli? Perhaps also the output of "ld all show". <BR /><BR />I seem to recall that unused disks show up as "unassigned" or similar. Wed, 27 Oct 2010 21:58:27 GMT macosta 2010-10-27T21:58:27Z https://community.hpe.com/t5/operating-system-linux/command-for-virtual-config/m-p/4705886#M42577 I support DL380 and DL580 (G3-G7)hosts running Red Hat Enterprise 3, 4, and 5.<BR /><BR />Would like to know which physical disks make up the hpa logical drive.<BR />The hpacucli command shows pd and the logical disk, but I can not determine if all the physical disks are used in the logical drive.<BR />Is this a case where the answer is always "All of them"?<BR /> Wed, 27 Oct 2010 18:53:18 GMT https://community.hpe.com/t5/operating-system-linux/command-for-virtual-config/m-p/4705886#M42577 Robert S. White 2010-10-27T18:53:18Z https://community.hpe.com/t5/operating-system-linux/command-for-virtual-config/m-p/4705887#M42578 Can you post the output of "pd all show" from hpacucli? Perhaps also the output of "ld all show". <BR /><BR />I seem to recall that unused disks show up as "unassigned" or similar. Wed, 27 Oct 2010 21:58:27 GMT https://community.hpe.com/t5/operating-system-linux/command-for-virtual-config/m-p/4705887#M42578 macosta 2010-10-27T21:58:27Z