https://community.hpe.com/t5/operating-system-linux/remove-discovered-device-and-re-discover/m-p/5706359#M56148 <P>Hi,</P><P>&nbsp;</P><P>I have a c7000 with two 3Gb SAS switches in interconnect bays 5 &amp; 6.&nbsp; When I did the discovery from my insight control server, I hadn't noticed that the two switches had 169.254.0.0 addresses and not the addresses I assigned through epiba.&nbsp; I did a reset on each and they picked up the correct ip addresses.&nbsp; However, I can't figure out how to tell insight control to re-discover the switches.&nbsp; Any suggestions?</P><P>&nbsp;</P><P>Thanks!</P> Fri, 29 Jun 2012 15:17:44 GMT BradV 2012-06-29T15:17:44Z https://community.hpe.com/t5/operating-system-linux/remove-discovered-device-and-re-discover/m-p/5706359#M56148 <P>Hi,</P><P>&nbsp;</P><P>I have a c7000 with two 3Gb SAS switches in interconnect bays 5 &amp; 6.&nbsp; When I did the discovery from my insight control server, I hadn't noticed that the two switches had 169.254.0.0 addresses and not the addresses I assigned through epiba.&nbsp; I did a reset on each and they picked up the correct ip addresses.&nbsp; However, I can't figure out how to tell insight control to re-discover the switches.&nbsp; Any suggestions?</P><P>&nbsp;</P><P>Thanks!</P> Fri, 29 Jun 2012 15:17:44 GMT https://community.hpe.com/t5/operating-system-linux/remove-discovered-device-and-re-discover/m-p/5706359#M56148 BradV 2012-06-29T15:17:44Z